Bathroom Resealing in Kent

Our bathroom resealing service in Kent

Sealant that’s mouldy, cracked or peeling shouldn’t be left until there’s a leak. A photo of the joints helps when you ring 0345 464 0079 or email us, and we’ll give you a clear price for bathroom resealing in Kent. We are often asked to deal with a reseal done over the top of the old bead and sealant that has split, shrunk or peeled away, across wet rooms, sinks & splashbacks and baths.

On the day, we look over the joints with you first, so you know exactly what we’re doing. Surfaces next to the work are protected before any work begins. Most jobs take half a day or less for one room, longer when the kitchen is included.

1. First, each joint is checked for movement and signs of water.
2. Every trace of the old bead is removed, including the thin smear on the tiles.
3. The joint is cleaned, degreased and treated for mould.
4. When the joint is dry, and a bath has been filled with water, the new silicone goes on.
5. The bead is tooled smooth and you are told the cure time, generally around 24 hours.

How we quote

Rather than a set price list, we look at what your job involves: the amount of work, the old material and the access. You’ll know the price before we begin.

Why book with us

• 20+ years of sealant experience
• Full insurance on every job
• Tidy, careful work
• ARBOMaster approved applicator

How to get a quote

We do not publish a price list. Instead, your job gets its own clear quote. To get started, phone 0345 464 0079 or email us.

Landmarks near Maidstone

Typical jobs here are in homes near Paper Makers Arms, Maidstone Grammar School and St Philip's Church and the streets around them. You will also find River Len LNR (under half a mile north-east), South Borough Primary School (less than half a mile south) and St Augustine Academy (1.2 miles west). The nearest railway station is Maidstone West station, roughly 0.6 miles north-west of the centre. Well-known places in the area include Maidstone Carriage Museum (within half a mile north-west) and Oakwood Hospital (1.8 miles west). Not far away are Burham Down and Boxley Hills.

Looking after it afterwards

So the new joints stay in good condition:

• Run the extractor fan during and after every shower
• Check the joints every few months for splits or lifting
• Squeegee the walls and tray after use
• Don’t let bottles sit on the bead

Give the silicone time to cure before it gets wet, following the cure time we give you. Once it’s cured, wiping it down after use keeps it looking new.

A split bead lets water through every time the bath or shower is used. Left alone, it soaks into the floor, the wall behind the tiles or the ceiling below. Resealing early stops it.