Kent · England
Bathroom & kitchen resealing in Sissinghurst, Kent
Problem with your baths, showers and worktops in Sissinghurst? We remove the old material, prepare the joints and seal them properly.
- Water escaping at the shower enclosure
- Water getting behind the bath panel
- A reseal done over the top of the old bead
Looking after it afterwards
Aftercare is simple:
- Clean with a mild bathroom cleaner and a soft cloth
- Wait for the cure time we give you
- Keep bottles off the sealant line
- Do not leave water standing on kitchen joints
Keep water off the new bead until it has cured, which is usually around 24 hours. After that, a quick wipe after showering helps keep it clean.
A split bead lets water through every time the bath or shower is used. Left alone, it soaks into the floor, the wall behind the tiles or the ceiling below. Resealing early stops it.
About our bathroom resealing in Sissinghurst
Mr Mastic has more than 20 years’ experience of sealant work, and our applicators reseal bathrooms and kitchens across Sissinghurst. We are fully insured ARBOMaster approved applicators, and every job carries our 12-month guarantee. If you are dealing with water escaping at the shower enclosure and a bead that has pulled away from the tiles, we can help, on shower trays & enclosures, basins & vanity units and baths alike.
Homes around Sissinghurst are mostly houses and cottages rather than flats. Sealant and grout wear out here just as they do anywhere: everything old comes out before the new sealant or grout goes in.
There’s a 12-month guarantee on every job, whatever its size.
- Location
- Sissinghurst (TN17)
- Region
- Kent
- Cover
- One year on every job
- Quote
- A clear quote up front
- Phone
- 0345 464 0079
- Page updated
- 26 October 2026
Leave it or put it right?
A quick bead over the top of the old one might look better for a while, but it cannot stick to what’s underneath. Water creeps under it and mould follows, and the next reseal means two layers to cut out. Older cottages and farmhouses around Sissinghurst can have timber floors and frames, and water through a failed joint can rot timber if it’s left.
There are no prices on our website, because each job is priced on what it involves. Call for a quick quote.
What you get with us
- Experience in homes, commercial sites and hotels
- Anti-fungal silicone where joints get wet
- 20+ years of sealant experience
- Colour agreed with you before we start
Landlords, agents and businesses in Sissinghurst
Landlords and letting agents in Sissinghurst can book us as well as householders. Sealant work between tenants keeps a property looking cared for.
Whether it’s one flat or a portfolio, the work is the same standard: old sealant fully removed, joints prepared properly and a 12-month guarantee.
DIY sealant or a professional job?
If you do try it yourself, take your time over the preparation: take out all the old sealant, make sure the joint is clean and dry, and give it the full cure time. If it does not work out, we can still put it right.
Too much sealant is as bad as too little. A heavy bead looks messy and copes badly with movement, and the joint depth matters as much as the finish.
What happens on the day
On the day, there’s very little for you to do. Show us the job and we will take it from there. The job generally takes a morning or an afternoon for most single baths and showers from start to finish. Somewhere as small as Sissinghurst, access is often the only tricky part. For outside work, also let us know about exposed walls and any outbuildings involved.
- Protection goes down around the bath, shower or worktop.
- Old sealant is sliced away and the residue removed.
- We treat any mould and let the joint dry properly.
- Baths are filled first, then anti-fungal sanitary silicone is applied in a colour to suit.
- We finish the joint, clear up and tell you how long to leave it before it gets wet.
Preparing for the visit
- For indoor joints, keep the area dry beforehand if you can
- Clear items away from the joints we’re working on
- Keep pets and children clear of the area while we work
Get a quote
If you are in Sissinghurst and need bathroom resealing, call 0345 464 0079 or email us. Tell us what the problem is and where, and you’ll get a clear quote before work begins.
Related advice
Also near Sissinghurst
What else we do in Sissinghurst
When it isn’t the sealant
A few problems are outside what sealant work can do:
- A cracked shower tray or bath (that needs repair or replacement)
- Water coming from the plumbing rather than the joint
- Movement from a bath with loose feet or no proper support
If in doubt, phone 0345 464 0079 or send us an email and we’ll say what we think before you book.
What we seal
- Kitchen worktops & upstands
- Basins & vanity units
- Shower trays & enclosures
- Sinks & splashbacks
- Baths
- Wet rooms
Bathroom resealing around Sissinghurst
Hard water is the norm across most of the South East, so limescale builds up on sealant, grout and fittings, and it has to be cleaned off before new sealant goes in.
Schools such as Cranbrook School are buildings too, and its toilets, changing areas and kitchens need their sealant renewed like any other building’s. In the older streets around Church of the Holy Trinity, bathrooms in older houses have often been refitted more than once, with sealant laid over sealant. For landlords with property near Staplehurst station, mouldy sealant is one of the first things a new tenant notices, so it’s worth renewing between lets.
Sissinghurst is about 11 miles south of Maidstone, in Kent. Anywhere in TN17, we can carry out bathroom resealing at your property. 922 places in Kent are on our list, large and small. Crawley is on our list too, about 32 miles from Sissinghurst.
Our applicators cover all of TN17 for bathroom resealing and the streets around it. If you need bathroom resealing at a property on The Street, Milkhouse Cottages and Cobnut Close or a nearby road, we can help. Other places close to Sissinghurst include Wilsley Pound (1 mile west), Cranbrook Common (1 mile north), Wilsley Green (1 mile south-west), Knox Bridge (2 miles north) and Colliers Green (2 miles west). We also work in nearby towns such as Maidstone (11 miles north), Ashford (14 miles east), Royal Tunbridge Wells (13 miles west), Tonbridge (14 miles north-west), Kings Hill (13 miles north-west) and Foley Park (12 miles north).
Local landmarks in Sissinghurst
In Sissinghurst, that means homes and buildings near Crane Valley and The Bull Public House. The nearest railway station is Staplehurst station, about 4.3 miles north. Nearby you will also find Sissinghurst Castle (1.1 miles east) and Benenden Hospital (3.1 miles south-east).
Your questions about bathroom resealing in Sissinghurst
Can you do bathroom resealing in Sissinghurst?
Yes, Sissinghurst is within the area we cover. Our work covers London and the South East. Just ring 0345 464 0079 or send us an email with a few details of the job, and we’ll give you a clear price.
Will you come out to Sissinghurst?
Yes, we do. We work across London and the South East, and smaller places are part of that. Longer journeys are simply planned in advance.
Do you work for landlords and businesses?
Yes, we do. Domestic, commercial and hotel work are all part of what we do, and we’re fully insured.
Will the old sealant be removed?
Yes. All of the old material is cut out and the joint cleaned.
Can you just seal over the old silicone?
No. It’s a common reason for reseals failing. The old joint is stripped, cleaned and resealed from scratch.
Do you hold any approvals?
Yes. We’re an ARBOMaster approved applicator, the approved applicator scheme for Arbo sealants.
Where do you work from?
We work from Crawley. We cover Sissinghurst and the rest of Kent.
Will there be a smell?
It depends on the product. Some smell for a while, some hardly at all, and any smell fades as they cure.
How we quote for bathroom resealing
For a quick quote, just ask. The main things that affect it are:
- The size of the job
- How much old sealant there is and how hard it is to remove
- The product the joint needs
- The number of rooms or windows
Rather than a set price list, we look at what your job involves: the amount of work, the old material and the access. The price is agreed before we begin.
What we need to know
A few details help us give you an accurate quote. When you get in contact, it helps to mention:
- The rough size of the job
- If it’s domestic, commercial or a hotel
- What the problem is, such as mould, gaps, leaks or cracking
- Any access issues, like height or stairs
The more we know about the job, the more useful the quote. Tell us where the job is, what’s wrong and how much there is, and email photos if that is easy.