Kent · England
Stone Street Bathroom Resealing
Specialist bathroom resealing for Stone Street: the right sealant, proper preparation and a neat finish. Call for a quick quote.
- Cracked, shrunken or lifting silicone
- Black spots spreading through the bead
- Leaks into the floor or ceiling below
Bathroom resealing in Stone Street
The secret of a lasting bead is the preparation. Every bit of old silicone comes out, down to the thin film left on the tiles, then the joint is cleaned, degreased and treated for mould. New silicone goes on only when the joint is fully dry. If you have a reseal done over the top of the old bead and sealant that has split, shrunk or peeled away, we can help, on shower trays & enclosures, basins & vanity units and baths alike.
Homes around Stone Street are mostly houses and cottages rather than flats. The work is the same as anywhere: everything old comes out before the new sealant or grout goes in.
Each job carries a 12-month guarantee, whatever its size.
- Place
- Stone Street (TN15)
- Region
- Kent
- Cover
- One year on every job
- Quotes
- Quoted before any work starts
- Phone
- 0345 464 0079
- Page updated
- 26 October 2026
What sealant work cannot fix
Sealant is not the answer to every problem, and we’d rather say so up front. Sealant won’t put right:
- Movement from a bath with loose feet or no proper support
- Tiles that have come away from the wall
- Failed grout lines across the wall
If in doubt, call 0345 464 0079 or drop us an email and we will say what we think.
Where we work in Stone Street
- Basins & vanity units
- Sinks & splashbacks
- Shower trays & enclosures
- Baths
- Wet rooms
- Kitchen worktops & upstands
Bathrooms and kitchens in Stone Street
Most of the South East has hard water, which leaves limescale on sealant, grout and fittings.
For an older house near a landmark such as St Lawrence, walls and floors in older homes can move, and sealant and grout show it first. Letting a property close to Kemsing station? Then fresh sealant around the bath, shower and sink between tenancies helps a property present well and keeps leaks at bay.
Stone Street is about 3 miles east of Sevenoaks, in Kent. Homes, rented property, offices and hotels in Stone Street can book us for bathroom resealing, old or new, large or small. Every job comes with our 12-month guarantee. Stone Street is one of 922 towns and villages in Kent where we work. Our London page covers work nearby.
Every address in TN15 is within our area for bathroom resealing, from the main roads to the quietest streets. That includes homes and businesses on Church Road, Stone Street Road and Pond Lane and the roads around them. Neighbouring places we cover for bathroom resealing include Bitchet Green (1 mile south-west), Ivy Hatch (1 mile east), Styants Bottom (1 mile north), Godden Green (1 mile west) and Ightham (1 mile north-east). Within a short drive, we also cover Maidstone (12 miles east), Dartford (12 miles north), Sevenoaks (3 miles west), Royal Tunbridge Wells (9 miles south), Gravesend (12 miles north-east) and Tonbridge (5 miles south).
Local landmarks in Stone Street
Around Stone Street, our work takes us to homes and buildings near Sevenoaks Preparatory School, Ivy Hatch Nature Reserve and The Plough pub. The closest station to Stone Street is Kemsing station, about 1.9 miles north. Nearby you will also find Ightham Court (2.2 miles north-east) and Sevenoaks Hospital (2.8 miles north-west). Not far away are Dryhill Nature Reserve.
Nearby places to Stone Street
Also in Stone Street
Landlords, agents and businesses in Stone Street
Letting agents often deal with us directly. Tell us the address, the job and how access works and we’ll quote.
Hotels need rooms back in use, so the work can be planned room by room around your bookings where we can. We’ve worked in hotels as well as homes and businesses.
Questions from Stone Street
Can you do bathroom resealing in Stone Street?
Yes, Stone Street is within the area we cover. We work across London and the South East. You can call 0345 464 0079 or email us and tell us what needs doing.
Can you help a landlord with a rental near Kemsing station?
Yes, we work for landlords and agents. Just ring 0345 464 0079 or send us an email and tell us about the property, and we will send you a clear quote.
What information do you need?
Just the basics: where it is, what you’ve noticed and how we reach it. Then phone 0345 464 0079 or send us an email.
Is there any odour?
Some sealants have a smell while they cure, which fades as it sets. Ventilation helps.
Can you get rid of the black mould in my sealant?
Yes, we replace the mouldy bead. Cleaning products may lighten it, but the lasting fix is new anti-fungal silicone on a clean, treated joint. Airing the room well helps stop it returning.
What do you put in the joint?
We choose the sealant for the joint, not the other way round. Movement, water and weather all affect the choice.
Is the work guaranteed?
Yes. We give a 12-month guarantee on every job, and we’re fully insured.
Do you work for hotels and businesses?
Yes. Commercial and hotel work is a large part of what we do. We can talk about working times when we quote.
What we do, step by step
Every visit runs the same way: we check the joints, protect the area around them, do the work and tidy away. It normally takes two to three hours for a typical bath, depending on how much old sealant there is. Somewhere as small as Stone Street, access is often the only tricky part. If the job is outside, mention outbuildings, exposed walls and how to reach them.
- First, each joint is checked for movement and signs of water.
- The old silicone is cut out completely, along with the film it leaves on the tiles.
- The joint is cleaned, degreased and treated for mould.
- With the joint dry, and any bath loaded with water, a single bead of anti-fungal silicone is applied.
- We tool the bead to a neat finish and give you the cure time, generally around 24 hours.
Getting ready for the visit
- Keep children and pets away from the work area
- Let us know about parking restrictions
- Tell us about any water getting in
How to get a quote
A good description makes for an accurate quote. Let us know the location, the problem and roughly how many joints.
Advice
What affects the quote in Stone Street
Some jobs are bigger than they look, and some smaller. What affects the quote:
- The product the joint needs
- The amount of work
- How easy the joints are to reach
- How many areas need sealing
The cost reflects the work involved, not a rough estimate. That is why we ask a few questions first and give you a clear quote before work begins.
Helping us quote
You don’t need to know the technical terms. It helps if you can tell us:
- How we’d reach the joints
- The address or postcode of the job
- What’s wrong with the joints now
- A few pictures by email, if you can
For bathroom resealing in Stone Street, ring 0345 464 0079 or email us. Tell us what the problem is and where, and we will agree the price before any work begins.
When to call us in Stone Street
A bath shifts a little every time it’s filled and emptied. Acrylic in particular gives slightly under the weight of water and a person, and a tray that is not fully bedded can rock. That movement works at the bead until it splits or peels away.
Most people get in touch when they notice something like this:
- A joint torn by a bath that flexes
- Gaps between the worktop and the wall
- Two layers of silicone, both failing
- Smears of silicone across the tiles
If you look after a building such as St Lawrence Church of England Primary School, washroom and kitchen sealant there needs the same care as at home, and schools and businesses are part of our work as well as homes.
What your quote should include
- Whether all the old sealant comes out first
- How much experience the applicator has
- What preparation is included
- Is VAT in the price?
DIY sealant or a professional job?
Too much sealant is as bad as too little. A heavy bead looks messy and copes badly with movement, and the joint depth matters as much as the finish.
If you are set on DIY, put the effort into preparation: remove every trace of old sealant, clean and dry the joint, and follow the product’s cure time. If it doesn’t work out, we can still put it right.
How the job changes by surface
Kitchen worktops & upstands
Laminate worktops swell if water gets into the core. A sound joint along the back edge stops that.
Sinks & splashbacks
The edge of an inset sink is a common place for water to get under the worktop. Where the sealant around the visible edge has failed, we renew it.