Highland · Scotland
Bathroom Resealing in Ardersier
Our applicators work in Ardersier on bath, shower, basin, wet room, worktop and sink resealing. Old sealant removed completely, joints prepared properly and a one-year guarantee.
- Black spots spreading through the bead
- A reseal done over the top of the old bead
- Splits where the tray meets the wall
Landlords, agents and businesses in Ardersier
From a single let to a portfolio, you get the same standard of work: the old material taken out, careful preparation and a 12-month guarantee.
Housing providers, facilities teams and property managers book us too in Ardersier and across Highland. Several sites can be quoted together.
Bathroom resealing in Ardersier, done properly
Sealant is the soft line between a bath, shower or worktop and the wall. Once it cracks or goes mouldy, water starts to find its way through. Every trace of the old sealant is taken out and replaced with anti-fungal sanitary silicone. If you have smears of silicone across the tiles and black spots spreading through the bead, we can put it right, on basins & vanity units, wet rooms and shower trays & enclosures alike.
Across smaller places in Scotland, homes range from stone and harled cottages to newer houses. Where a building moves, cracked grout and split sealant are generally the first signs.
Whatever the size of the job, you get the same one-year guarantee in Ardersier and across Highland.
- Location
- Ardersier (IV2)
- Region
- Highland
- Guarantee
- 12 months on all our work
- Quotes
- A clear quote up front
- info@mrmastic.co.uk
- Page updated
- 26 October 2026
Aftercare tips
A little care helps the new joints last. Our advice:
- Dry the bead with a towel now and then
- Avoid abrasive pads on the sealant
- Don’t let bottles sit on the bead
- Wipe up water along the back of the worktop
Treat the new bead gently when you clean: warm soapy water and a soft cloth do the job. Avoid scouring pads and anything sharp, because a damaged bead gives mould a foothold.
Each shower pushes a little more water through a failed joint. Left alone, it soaks into the floor, the wall behind the tiles or the ceiling below. Early resealing closes the gap before damage is done.
Surface by surface
Baths
Acrylic baths flex the most, and even steel and cast iron baths settle slightly when full. Filling the bath first allows for that movement.
Wet rooms
In a wet room, the joints between floor and walls take standing water. They’re resealed with anti-fungal sanitary silicone, working on the surface joints, not the tanking or drainage.
What affects the quote in Ardersier
You’ll get a clear quote before work begins. It’s based on:
- Mould in or behind the old joints
- The number of rooms or windows
- How much old sealant there is and how hard it is to remove
- The number and length of the joints
A few things move the cost up or down: the old material and how easily it comes out, whether mould needs treating, and whether the work is at height. Your quote takes all of that into account.
Helping us quote
The more you tell us, the more accurate the quote. When you get in contact, it helps to mention:
- Access, such as stairs, a lift or height
- What’s wrong with the joints now
- Whether it’s a home or a business
- Whether it has been sealed before
Call for a quick quote, or email us if that’s easier. Describe what needs sealing and we will talk you through the work and send you a clear quote.
Also in Ardersier
DIY sealant or a professional job?
Too much sealant is as bad as too little. A thick, smeared bead looks untidy and doesn’t move well, and the joint depth matters as much as the finish.
If you’ve already had a go yourself, that’s fine. We cut it out and start again, so just mention it when you contact us.
FAQs for Ardersier
Will you come out to Ardersier?
Yes, smaller places are covered as well as towns. We work across all of Scotland. Just mention lanes, gates or anything else about the route when you book.
Can you do bathroom resealing in Ardersier?
Yes, Ardersier is within the area we cover. Our work covers the whole of Scotland. Just email us at info@mrmastic.co.uk with a few details of the job.
How long will the resealing take?
It depends on how many joints there are and how much old sealant has to come out. For most single baths or showers, allow a couple of hours.
Can you work on commercial sites?
Yes. We’ve worked for hotels, offices and other businesses, and we’re fully insured.
Is it messy?
Very little: the area around the joints is protected first, and we clear up the old sealant and our materials before we leave.
What does bathroom resealing cost?
It depends on the job, so we quote each one individually. To get one, send an email to info@mrmastic.co.uk and tell us what needs doing and where.
Can mouldy silicone be sorted out?
Yes, we can. The old sealant comes out, the mould is treated, and we reseal with anti-fungal sanitary silicone.
Is it OK to put new sealant on top of the old bead?
No. Fresh silicone can’t stick to the old bead, so it lifts and traps water and mould underneath. All the old sealant comes out first.
What happens if it’s left?
Bleach and mould sprays may lighten black marks for a while, but where mould is inside the silicone it generally comes back. The lasting answer is to remove the bead and start again. Out of town in Scotland, exposed walls take a lot of weather, and once water gets behind a failed joint, damp in stone or harled walls is slow to dry out.
The cost reflects the work involved, not a rough estimate. That is why we ask about the job first.
What you get with us
- Fully insured
- Homes, businesses and hotels
- Anti-fungal silicone where joints get wet
- Approved under the ARBOMaster scheme
The process
When we arrive, we start by going over the job with you, so you know exactly what we’re doing. Surfaces next to the work are protected before any work starts. The work normally takes a morning or an afternoon for most single baths and showers. Outdoor work around Ardersier depends on the weather, as sealant needs a dry surface, so an outdoor job can move if the forecast changes. Indoor work goes ahead whatever the weather.
- We cover the area around the joints we are working on.
- We cut away the old sealant and clean off what’s left.
- We treat any mould and let the joint dry properly.
- Any bath is filled with water, then we lay a bead of anti-fungal silicone in white, clear or a matching colour.
- We finish the joint, clear up and tell you how long to leave it before it gets wet.
Preparing for the visit
- Tell us about any water getting in
- Keep pets and children clear of the area while we work
- Tell us about access, such as stairs, a lift or high-level joints
Ask for a quote
Need a quote? Please send an email to info@mrmastic.co.uk and tell us about the job. You’ll know what we plan to do, and what it will cost, before any work begins.
Advice
Ardersier homes and their sealant
Ardersier is close to the coast. Near the coast, holiday lets and guest houses can see bathrooms used by one guest after another, and sealant and grout that work that hard wear out sooner. Scotland’s water is generally soft, so sealant and grout see less limescale than in much of England. Mould is another matter: a bathroom that stays damp still turns sealant and grout black.
Rented homes near Inverness Airport station change hands often, and fresh sealant around the bath, shower and sink between tenancies helps a property present well and keeps leaks at bay. In and around Ardersier, as anywhere, good bathroom resealing starts with a clean, dry, properly prepared joint.
Ardersier is about 6 miles west of Nairn, in Highland. From the centre of Ardersier to the outskirts, bathroom resealing is available for homes and businesses alike. We cover 253 towns and villages across Highland, large and small. There’s also a page for Aberdeen, roughly 77 miles from Ardersier.
Here we cover the IV2 postcode area for bathroom resealing. Bathroom resealing is available to properties on Station Road, High Street and Cameron Drive and the roads around them. Neighbouring places we cover for bathroom resealing include Croy (3 miles south), Rosemarkie (3 miles north-west), Fortrose (4 miles west), Avoch (5 miles west) and Cawdor (5 miles east). Further out, we also cover Inverness (10 miles south-west), Nairn (6 miles east), Cradlehall (7 miles south-west), Merkinch (10 miles south-west), Dingwall (15 miles west) and Hilton (10 miles south-west). Island and remote addresses take a little more planning, so please mention your location when you drop us a line at info@mrmastic.co.uk.
Local landmarks in Ardersier
Ardersier’s nearest station is Inverness Airport station, about 2.3 miles south. Other landmarks nearby include Highland Aviation Museum (2.1 miles south-west) and Chanonry of Ross (3.7 miles west). Open spaces near Ardersier include Loch of the Clans and Fairy Glen.