Perth and Kinross · Scotland

Regrouting in Balgowan, Perth and Kinross

We cover Balgowan for raking out old, cracked or stained grout and regrouting tiled walls and floors. Old material cut out, joints cleaned and sealed neatly and a 12-month guarantee.

  • Grout in corners that has cracked
  • Discoloured grout on otherwise sound tiles
  • Gaps where the shower grout has gone

Regrouting for Balgowan homes and businesses

What the job involves on each surface

Shower walls

Showers put more water on grout than anywhere else. We replace it, and reseal the corners.

Corners and edges

Corners flex as the building moves, so we seal them rather than grout them.

Regrouting in Balgowan

Our applicators rake out the old grout to an even depth, without damaging the edges of the tiles. After vacuuming, new grout goes in and the tiles are wiped clean, and the corners get fresh silicone. Typical jobs include a grout colour that no longer suits the room and shower grout that has worn away, on bathroom wall tiles, shower walls and wet rooms.

Across smaller places in Scotland, homes range from stone and harled cottages to newer houses. Older buildings can move a little, and that shows first in cracked grout and split sealant.

Each job carries a 12-month guarantee.

Place
Balgowan (PH1)
Wider area
Perth and Kinross
Guarantee
12 months on all our work
Quote
A clear price before we start
Email
info@mrmastic.co.uk
Last updated
26 October 2026
Silicone being applied where a shower enclosure meets beige wall tiles

Regrouting around Balgowan

Private landlords in Scotland must be registered and meet the Repairing Standard, which includes keeping fixtures and fittings in reasonable repair. Tired, leaking sealant is worth putting right before a new tenant moves in. Scottish Water supplies are generally soft, so limescale is less of a problem than in hard-water areas. But mould still grows into sealant and grout in a room that does not dry out.

In and around Balgowan, as anywhere, good regrouting starts with a clean, dry, properly prepared joint. For jobs in and around Balgowan, choosing the right material for each joint is as important as a tidy finish.

Balgowan is about 7 miles west of Perth, in Perth and Kinross. We provide regrouting to householders, landlords and businesses in Balgowan and the surrounding area. Our area takes in 107 places across Perth and Kinross, large and small. There’s also a page for Dundee, about 26 miles away.

Jobs for regrouting in PH1 is quoted and booked the same way as anywhere else. You’ll find streets such as Earn Drive, Millglen Drive and Munro Avenue, and we cover them all. Close by, we work in Madderty (3 miles south-west), Methven (3 miles north-east), St David's (3 miles south-west), Tibbermore (4 miles east) and Aberuthven (5 miles south). Further out, we also cover Perth (7 miles east), Crieff (8 miles west), Auchterarder (7 miles south-west), Kinross (14 miles south-east), Letham (6 miles east) and Scone (9 miles east).

Near you in Balgowan

Nearby you’ll also find Methven Castle (3.7 miles north-east). Not far away are Dupplin Lake.

Map of Balgowan © OpenStreetMap contributors

Aftercare tips

Looking after new joints is easy, and it makes a real difference:

  • Clean with a soft brush, not anything metal
  • Don’t ignore a tile that feels loose
  • Rinse soap off the tiles after each shower
  • Stick to mild products for cleaning grout

Leave the area unused for as long as we advise, so it can harden properly. From then on, a quick rinse after showering helps and let the room air.

Cracked grout does not stay cracked for long. Water gets behind the tiles, and they can begin to come away and early regrouting can avoid a much bigger job.

DIY sealant or a professional job?

Not every job suits DIY: high-level joints, fire-rated gaps, external movement joints and big jobs need the right product, the right access and the right method.

If you do try it yourself, take your time over the preparation: take out all the old sealant, make sure the joint is clean and dry, and give it the full cure time. If it fails, we can still redo it.

When it is not the sealant

Some problems need a builder, plumber or other trade rather than us:

  • Waterproofing that has failed below the tiling
  • Loose tiles, which need refixing first
  • Movement in a stud wall or floor

If you’re not sure, just send an email to info@mrmastic.co.uk and we’ll give you a straight answer before you book.

Joints and surfaces we work on

  • Bathroom wall tiles
  • Bathroom floors
  • Tiled floors
  • Kitchen splashbacks
  • Shower walls
  • Wet rooms

FAQs for Balgowan

Is Balgowan in your area for regrouting?

Yes. Our work covers the whole of Scotland, and Balgowan is part of that. Just email us at info@mrmastic.co.uk with a few details of the job.

Is regrouting in Balgowan guaranteed?

Every job comes with our 12-month guarantee, wherever it is. We are also fully insured and ARBOMaster approved.

Which products do you use?

Quality sealants from brands including Arbo and Everbuild, chosen to suit the joint. We explain the product when we quote.

Are you insured?

Yes. We are fully insured, and we’ve been doing sealant work for more than 20 years.

Can you regrout just the shower?

Yes. We will look at the rest of the room too and let you know if more needs doing.

Can you do several jobs on one visit?

Yes. Tell us about everything you’d like done.

Can tenants book the work?

Yes. Check with your landlord; we can send the quote to them too.

Do you grout the corners?

Flexible sealant. Grout is for the joints between tiles and moving joints need sealant.

What we do, step by step

Before we leave, we go over the finished joints with you and explain the cure time. The work normally takes a few hours for a shower enclosure, longer for a whole room, depending on the size of the job. Outside jobs in Balgowan need a dry day, because sealant won’t bond to a wet joint, so external jobs may need to move if the day turns wet. Indoor work goes ahead whatever the weather.

  1. We start by checking the tiles for any that are loose or hollow.
  2. The old grout comes out to a consistent depth, without damaging the tiles.
  3. We vacuum the joints and clean out the dust.
  4. We fill the joints with new grout, then clean the tiles.
  5. Corners and edges are resealed with flexible silicone, not grout.

Before we arrive

  • Tell us about any previous sealing or DIY attempts
  • Clear the area around the work
  • Mention any sign-in or site rules at work premises

How to get a quote

We don’t publish a price list. Instead, your job gets its own clear quote. To get started, email us at info@mrmastic.co.uk.

Get a price

Related advice

Quotes for regrouting in Balgowan

We don’t publish a price list, because no two jobs are the same. What we look at:

  • How many areas need sealing
  • Whether there’s mould to deal with
  • When we can work, for business premises
  • The type of sealant required

No two jobs are quite the same, so each one gets its own quote. Size, access and the product the joint needs all play a part, and we will explain the quote if you ask.

What we need to know

There’s no need for technical detail. It helps if you can tell us:

  • Any previous sealing or DIY work
  • The type of property
  • The rough size of the job
  • The problem you’ve noticed

Getting a quote is simple: let us know the job and the location and its rough size. Photos by email help us understand the job, and we’ll take it from there.

Landlords, agents and businesses in Balgowan

Businesses can book us for washrooms, kitchens, offices and more. On commercial sites, working times can be discussed when we quote.

Housing providers, facilities teams and property managers book us too. Several sites can be quoted together, and we’re fully insured.

20+ yearsMastic and sealant specialists
ARBOMaster approvedApproved applicator for Arbo sealants
Fully insuredDomestic, commercial and hotels
One-year guaranteeOn every job