Greater London · England
Regrouting in Norbiton, Greater London
Raking out old, cracked or stained grout and regrouting tiled walls and floors for Norbiton, backed by a 12-month guarantee. Call for a quick quote.
- Good tiles let down by tired grout
- Floor grout that will not come clean
- Gaps where the shower grout has gone
Regrouting in Norbiton
Most regrouting jobs include resealing too. Grout is for the joints between tiles, but internal corners and edges flex, so they’re sealed with silicone rather than grout. Doing both at once leaves the whole area sound. Typical jobs include grout that stays dark however much it’s cleaned and discoloured grout on otherwise sound tiles, across shower walls, wet rooms and tiled floors.
London’s water is hard, so limescale builds up along sealant lines, in grout and on fittings. In Norbiton, regrouting is as much about a room looking cared for as about keeping water out.
The work is guaranteed for twelve months. If something is not right with it in that time, tell us and we will put it right.
- Place
- Norbiton (KT2, KT1, KT3)
- Wider area
- Greater London
- Guarantee
- 12 months on all our work
- Quote
- Quoted before any work starts
- Call
- 0345 464 0079
- Updated
- 26 October 2026
What regrouting looks like in Norbiton
In a London flat, water from a failed bath or shower seal can reach the neighbours below, so tired sealant is best dealt with early. London has hard water, so limescale builds up on sealant, grout and fittings, and it has to be cleaned off before new sealant goes in.
For an older house near a landmark such as Church of St Peter, bathrooms in older houses have often been refitted more than once, with sealant laid over sealant. Letting a property close to Norbiton station? Then a regrout while the flat is empty is quicker than working around a tenant. As a London address, Norbiton can be tricky for parking: tell us about permits, visitor bays or off-street space when you book.
Norbiton is about 3 miles west of Wimbledon, in Greater London. Wherever you are in the KT2 postcode area, our applicators can take on regrouting. We cover 764 towns and villages across Greater London, from the larger towns to small villages. There’s also a page for London, roughly 10 miles from Norbiton.
Jobs for regrouting in KT2, KT1 and KT3 is quoted and booked the same way as anywhere else. If you need regrouting at a property on New Road, York Road and Orme Road or a nearby road, our applicators can take on the job. Neighbouring places we cover for regrouting include Kingston upon Thames (1 mile west), Coombe (1 mile north-east), New Malden (1 mile south-east), Motspur Park (1 mile east) and Coombe Hill (2 miles north-east). We also work in nearby towns such as London (10 miles north-east), City of Westminster (9 miles north-east), Marylebone (9 miles north-east), Kensington (7 miles north-east), St Pancras (11 miles north-east) and Shoreditch (12 miles north-east).
Around Norbiton
Locally, jobs take us to homes and businesses close to Kingston Grammar School, Tiffin School and The Black Horse pub. Norbiton has its own railway station: Norbiton station. Well-known places in the area include Kingston Hospital (under half a mile north) and Bentall Centre (0.9 miles west). Not far away are Rose Walk and Kingston Hill Road area.
Why act early in Norbiton
Regrouting won’t help where tiles have come away. We’ll tell you before we start, so you can decide what to do. Where the tiles are sound, regrouting is far less disruptive than retiling. In London conversions, one flat’s bathroom is often above another flat’s ceiling, so a small leak from tired sealant can mean a neighbour’s ceiling and a lot of disruption. Putting it right early is much less trouble.
A few things move the cost up or down: the old material and how easily it comes out, whether mould needs treating, and whether we need extra access for height. We take all of that into account in your quote.
Why book with us
- Every job guaranteed for a year
- Approved under the ARBOMaster scheme
- Homes, businesses and hotels
- Anti-fungal silicone where joints get wet
Read our cost guide and customer reviews.
What we do, step by step
Our applicators work methodically: protection first, then preparation, sealing and a tidy-up. Typically it takes a few hours, or longer for a fully tiled room. Many London jobs are in flats, so we come ready for stairs, narrow hallways and shared entrances. If the building has a concierge, managing agent or access rules, tell us when you book.
- We agree the area to be regrouted and point out any loose tiles.
- Grout is raked out without chipping the tiles.
- Dust is cleared from every joint.
- The new grout goes in, then the tile faces are cleaned.
- Internal corners and edges are resealed.
Preparing for the visit
- Clear items away from the joints we are working on
- Mention any parking rules near the property
- Let us know if you’ve seen damp or leaks
Getting a quote
For a quick quote, get us on the phone, or send an email if you’d rather. Tell us about the joints that need doing and we’ll talk you through the work before giving you a price.
Read more
Keeping the joints in good condition
After the cure time, these simple habits help:
- Don’t ignore a tile that feels loose
- Use gentle cleaners on grout
- Use a squeegee on the tiles after showering
- Run the extractor fan during and after a shower
A squeegee or cloth over the tiles after use stops soap and water sitting on the grout. Ventilate the room well so the grout dries between uses.
Leaving failed grout can mean tiles come loose. Once that happens, regrouting won’t fix it so early action pays.
DIY versus a professional finish
Overfilling a joint is a classic DIY mistake. A heavy bead looks messy and copes badly with movement, and getting the depth right matters as much as the look.
Sealing over old silicone is the commonest DIY error. New silicone will not bond to old, so it peels away and traps moisture behind it. Everything old must be removed first.
Landlord and commercial work in Norbiton
Letting agents often deal with us directly. Send the address, what’s needed and the access arrangements.
For anyone letting property in or around Norbiton, jobs at different addresses can be quoted together. Send us the addresses and the work at each.
What else we do in Norbiton
Surface by surface
Kitchen splashbacks
Kitchen grout collects grease and food splashes. Stained grout is best replaced.
Shower walls
Most regrouting jobs include a shower. Cracked or missing grout here lets water behind the tiles.
How we quote for regrouting
You will get a clear quote before work begins. It’s based on:
- Whether old sealant or filler has to be cut out
- How easy the joints are to reach
- The type of sealant required
- Any working-time requirements on site
Instead of a standard rate, we look at what your job involves: the amount of work, the old material and the access. You’ll know the price before we begin.
Asking for a quote
Before you ask for a quote, have a think about:
- Whether it’s a home or a business
- How many joints, rooms or windows are involved
- A few photos by email, if you can
- If someone has resealed it before
We don’t publish a price list. Instead, we give you a clear quote for your job. To get started, phone 0345 464 0079 or drop us an email.
Questions from Norbiton
I let a flat near Norbiton station. Can you help?
Yes, rental work is part of what we do. You can call 0345 464 0079 or email us with the address and a few details, and we’ll give you a fixed price before work begins.
Can parking be tricky for a visit in Norbiton?
Parking in Norbiton, as in most of London, takes a little planning: a visitor permit or a nearby bay makes the day run more smoothly.
Do you guarantee regrouting?
There’s a 12-month guarantee on every job, including regrouting.
Can you work on commercial sites?
Yes, regularly. We can plan bigger jobs in stages.
Do you regrout part of a bathroom, like the shower?
Yes, we often do. Shower grout tends to go before the rest, so many people regrout just that part.
Can you seal over the old sealant?
No. Fresh sealant does not stick to old sealant, and anything trapped underneath, including mould and water, stays there. We remove it all first.
Can I do it myself?
Some simple jobs can be done by a careful DIYer. The usual mistakes are sealing over old sealant, sealing a damp joint and using too much.
Where is Mr Mastic based?
Our base is in Crawley, and we work across South East England, London and Scotland.