Highland · Scotland
Torridon External Mastic
Sealing brickwork movement joints, render, cladding and façade joints for Torridon, backed by a one-year guarantee. Ask us for a quote.
- Old sealant gone brittle and cracked
- Cracked joints where brick meets render or frames
- Joints pointed up with cement by mistake
External mastic in Torridon, done properly
External mastic is a job where short cuts show quickly. New sealant over old, joints packed with mortar and beads with no backing all tend to fail early. We strip the joint back and start again. Common call-outs are for movement joints filled with mortar instead of sealant and joints with sealant missing in places, across façade panels, copings & trims and joints between brick and frames.
Outside joints can only be sealed when they’re dry, so work in Torridon depends on the weather. Let us know about access to every wall and roofline.
All of our work is guaranteed for twelve months, and the guarantee is the same wherever you are.
- Place
- Torridon (IV22)
- Region
- Highland
- Cover
- One year on every job
- Quote
- A clear price before work begins
- info@mrmastic.co.uk
- Last updated
- 26 October 2026

External mastic in Torridon: local notes
Torridon is close to the coast, where wind-driven rain is a fact of life and, nearer the shore, so is salt air. Both are hard on movement joints and outside wall joints, which can dry out and crack sooner where a building faces the weather. Torridon is in the west of Scotland, which is wetter than the east, which means movement joints and outside wall joints has to cope with a lot of rain.
For jobs in and around Torridon, choosing the right material for each joint is as important as a tidy finish.
Torridon is in Highland. Torridon gets the same service as everywhere we cover: old sealant removed completely, careful preparation and a one-year guarantee. 253 places in Highland are on our list.
Our applicators cover all of IV22 for external mastic. Close by, we work in Shieldaig (5 miles west), Balnacra (8 miles south-east), Srath Carran (9 miles south), Achintee (9 miles south) and Lochcarron (10 miles south). If you’re somewhere remote, a little more planning is needed, so let us know when you get in touch.
Around Torridon
The countryside around Torridon includes Loch an Eoin.
Why act early in Torridon
The longer a joint stays open, the more water the wall takes in. Wet masonry is more easily damaged by frost around the joint, so the damage spreads beyond the joint. When the nearest tradesperson is a drive away, it’s tempting to leave a small leak, but water through a failed joint keeps working away until it’s fixed.
Rather than a set price list, we look at what your job involves: the amount of work, the old material and the access. You will know the price before we begin.
What you get with us
- Sealant colour chosen to suit
- A 12-month guarantee on all work
- White, clear, grey or another colour, product permitting
- Anti-fungal sanitary silicone in wet areas
See our cost guide or our reviews.
What affects the quote in Torridon
Call for a quick quote. The main things that affect it are:
- Working hours on commercial sites
- Mould in or behind the old joints
- Access and height
- Which sealant suits the joint
The cost reflects the work involved, not a rough estimate. That’s why we ask about the job first and agree the price before starting.
What to tell us for a quote
A few details help us give you an accurate quote. When you get in contact, it helps to mention:
- Photos by email, if that’s easy
- The rough size of the job
- Any previous sealing or DIY work
- If it’s domestic, commercial or a hotel
Want a quote for external mastic? Please drop us a line at info@mrmastic.co.uk and tell us about the job. We will explain what we’d do and send you a clear quote before work begins.
Torridon questions
Can you do external mastic in Torridon?
Yes, Torridon is within the area we cover. We work across all of Scotland. Just drop us a line at info@mrmastic.co.uk with a few details of the job.
Is Torridon within the area you cover?
Yes, smaller places are covered as well as towns. Our work covers the whole of Scotland. Let us know about access, parking and anything unusual about getting there when you book.
Are you insured?
Yes. We are fully insured.
Do you do commercial work?
Yes. We work in offices, washrooms, hotels and other commercial premises, as well as homes. We can talk about working times when we quote.
Can I do it myself?
Sometimes. Preparation is everything: all the old sealant out, and a clean, dry joint. We can always put it right if it fails.
Can you seal joints between render and window frames?
Yes. Joints between dissimilar materials are a big part of external work. We use a flexible sealant suited to both surfaces.
What is a movement joint?
It’s a deliberate gap that lets the wall expand and contract without cracking. It’s sealed with a flexible sealant, not mortar.
Will it make a mess?
We keep the work tidy. We protect what’s around the joints.
When to call us in Torridon
If plants are growing out of a joint, the sealant has normally failed or was never there. Dirt and roots then trap moisture in the joint.
Any of these means the joints need attention:
- Hard, crazed mastic that has stopped moving
- Cracked joints where brick meets render or frames
- Failed sealant between panels on a façade
- Movement joints with cracked, split or missing sealant
In and around Torridon, as anywhere, good external mastic starts with a clean, dry, properly prepared joint.
What to look for in a quote
- Which colour the sealant will be
- Is the old sealant removed completely?
- What guarantee comes with the work
- How the joint is cleaned and prepared
Towns and villages near Torridon
What else we do in Torridon
How to look after the new joints
Once the sealant has cured, a few habits help it last:
- Check the sealant is paintable before painting near it
- Walk round the building once a year and look at the joints
- Wash walls gently around the sealant
- Fix overflowing gutters above sealed joints
Give the sealant the cure time we tell you before anything rubs against it. The surface skins over quickly, but full cure takes longer.
Water getting behind cladding or render can go unnoticed for a long time. When it finally shows inside, the joint may have been open for years, so it’s worth resealing at the first signs.
The process
There is not much for you to do on the day. Show us the job and we’ll take it from there. The job generally takes a few hours to a few days, depending on the length of joint and the access from start to finish. In smaller Scottish places, parking is usually less of an issue than access and distance. Tell us how to find the property and how to reach the work.
- Each joint is checked and the colour of the new sealant agreed.
- Failed sealant is removed back to clean, sound faces.
- Backing rod goes in so the sealant can stretch between the two faces.
- We prime the faces where required.
- A low-modulus exterior sealant is gunned in and tooled to a neat finish.
Getting ready for the visit
- Plan for the work area to be out of bounds to pets and children
- Let us know about earlier repairs to the joints
- Clear items away from the joints we’re working on
Getting a quote
For external mastic in Torridon, drop us a line at info@mrmastic.co.uk. A short description of the job and where it is helps us quote, and you will get a clear quote before work begins.
Related advice
How the job changes by surface
Concrete and blockwork
Concrete and block walls shrink as they dry and move with temperature. Their movement joints are sealed over backing rod with a flexible sealant.
Brickwork movement joints
Brick walls have vertical movement joints to absorb expansion. They’re resealed over backing rod with a low-modulus sealant coloured to suit the wall.
DIY sealant or a professional job?
If you do try it yourself, take your time over the preparation: take out all the old sealant, make sure the joint is clean and dry, and give it the full cure time. If it does not work out, we can still put it right.
Too much sealant is as bad as too little. A heavy bead looks messy and copes badly with movement, and getting the depth right matters as much as the look.
