Highland · Scotland

Bathroom Resealing in Corran

Our applicators work in Corran on bath, shower, basin, wet room, worktop and sink resealing. Old sealant removed completely, joints prepared properly and a 12-month guarantee.

  • New sealant laid over old sealant that is now lifting
  • Smears of silicone across the tiles
  • Splits where the tray meets the wall

Bathroom resealing for Corran homes and businesses

Bathroom resealing in Corran

Mr Mastic has more than 20 years’ experience of sealant work, and our applicators reseal bathrooms and kitchens across Corran. We are ARBOMaster approved and fully insured, and the work comes with a 12-month guarantee. Typical jobs include water getting behind the bath panel and black mould in the silicone that won’t clean off, across shower trays & enclosures, basins & vanity units and kitchen worktops & upstands.

For a place like Corran, the job is the same as anywhere: everything old is cut out, the joints are cleaned and dried, and new sealant or grout goes in. The journey and access are simply planned in advance.

Each job carries a 12-month guarantee, whatever its size.

Silicone being applied where a shower enclosure meets beige wall tiles
Where
Corran (PH33)
Wider area
Highland
Guarantee
One year on every job
Quotes
A clear quote up front
Email
info@mrmastic.co.uk
Updated
26 October 2026

Bathroom resealing in Corran: local notes

Corran is within about 1 mile of the coast. Near the coast, holiday lets and guest houses can see bathrooms used by one guest after another, and sealant and grout that work that hard wear out sooner. Private landlords in Scotland must be registered and meet the Repairing Standard, which covers keeping fixtures and fittings in a reasonable state of repair. Tired, leaking sealant is worth putting right before a new tenant moves in.

Homes close to Ardgour Parish Church include some older properties, and walls and floors in older homes can move, and sealant and grout show it first.

Corran is in Highland. Every kind of property in Corran is covered for bathroom resealing. Every job comes with our 12-month guarantee. Corran is one of 253 towns and villages in Highland we cover. You can also see our page for Glasgow, roughly 71 miles from Corran.

Jobs for bathroom resealing in PH33 works the same way as everywhere else we cover. Nearby, we also carry out bathroom resealing in Clo Mhuillin (1 mile south-west), Inchree (1 mile east), Kentallen (3 miles south), Duror (5 miles south) and Ballachulish (5 miles south-east). Within a short drive, we also cover Fort William (8 miles north-east), Caol (10 miles north-east), Inverlochy (9 miles north-east) and Kinlochmore (11 miles east). If you’re somewhere remote, the job takes a little more planning, so let us know when you get in touch.

Around Corran

The countryside around Corran includes Ardsheal Hill and Lochan na Luireach.

Map of Corran © OpenStreetMap contributors

Different surfaces, different methods

Shower trays & enclosures

Water often gets past the wall profile of a shower enclosure. It’s resealed along with the tray joints, following the enclosure maker’s guidance on which side to seal.

Basins & vanity units

Basin joints are short and close to eye level: so we keep the line tidy and even, in white, clear or a colour to suit.

Common questions in Corran

Do you cover Corran for bathroom resealing?

Yes, Corran is within the area we cover. Our work covers the whole of Scotland. Just email us at info@mrmastic.co.uk with a few details of the job.

Will you come out to Corran?

Yes, we do. We work across all of Scotland, and smaller places are part of that. Longer journeys are simply planned in advance.

Is white the only colour available?

You’re not limited to white: clear, white and colours chosen to suit the room. We can help you pick when we quote.

What does bathroom resealing cost?

We do not publish prices, because the cost depends on the job: how much there is, what’s there now, how we reach it and what it needs. You’ll get a clear quote before work begins.

Can you get rid of the black mould in my sealant?

Yes, we can. We strip the bead, treat the joint and lay new anti-fungal silicone.

When can I use the bath or shower again?

After around 24 hours in most cases. We’ll tell you the cure time for the product we used.

Do you guarantee your resealing?

Yes. We give a 12-month guarantee on every job, and we’re fully insured.

Do you do commercial work?

Yes. Larger jobs can be planned room by room or area by area to suit the site.

What we are called out for in Corran

A bath shifts a little every time it’s filled and emptied. An acrylic bath flexes under load, and a tray that is not fully bedded can rock. Over time the joint tears or pulls away from the tile.

Common reasons people contact us include:

  • Mouldy sealant that has gone black
  • Two layers of silicone, both failing
  • Leaks into the floor or ceiling below
  • Water escaping at the shower enclosure

Around Corran, as everywhere, bathroom resealing is only as good as the preparation behind it.

What your quote should include

  • How long to leave it before use
  • What guarantee comes with the work
  • What insurance they hold
  • Whether all the old sealant comes out first

Choosing a sealant specialist

Honest limits

A few problems are outside what sealant work can do:

  • Leaks from a shower valve, waste or pipework (a plumber’s job)
  • A tray or bath that is cracked through
  • Loose or hollow tiles, or failed tanking behind them

Not sure which it is? You can email us at info@mrmastic.co.uk and we will tell you honestly before you book.

Where we work in Corran

  • Shower trays & enclosures
  • Wet rooms
  • Baths
  • Kitchen worktops & upstands
  • Basins & vanity units
  • Sinks & splashbacks

How we quote for bathroom resealing

Every job gets its own quote. These are the things that affect it:

  • Mould in or behind the old joints
  • The number of rooms or windows
  • Whether the work is at height
  • The amount of work

Leaving a failed joint generally makes the job bigger, not smaller, as water and mould keep getting in. If you are unsure, send an email to info@mrmastic.co.uk and we will give you an honest view and a quote.

What to tell us for a quote

Photos help, but a description is a good start. Please mention:

  • The problem you’ve noticed
  • Pictures of the joints, sent by email
  • Where the property is
  • Roughly how big the job is

We don’t publish a price list, as no two jobs are quite the same. Instead, your job gets its own clear quote. To get started, email us at info@mrmastic.co.uk.

Why deal with it now?

A failed joint gets more costly to put right the longer it’s left. Once water is behind the bath, it can reach floorboards, panels and the ceiling underneath, and that’s a far bigger job than a reseal. Out of town in Scotland, exposed walls take a lot of weather, and once water gets behind a failed joint, damp in stone or harled walls is slow to dry out.

Doing several joints on one visit is generally more efficient than separate visits, so tell us about everything that needs sealing. You’ll get one clear quote for the whole job.

Why choose Mr Mastic in Corran

  • Any old sealant cut out fully, not covered over
  • Fully insured
  • Colour agreed with you before work begins
  • White, clear, grey or coloured to suit, where the product allows

Read what affects the cost or customer reviews.

What we do, step by step

We bring everything the job needs with us. After a quick look at the joints together, the area is protected and the work begins. It normally takes a morning or an afternoon for most single baths and showers. Outside jobs in Corran need a dry day, because sealant won’t bond to a wet joint, so external jobs may need to move if the day turns wet. Work indoors isn’t affected.

  1. Protection goes down around the bath, shower or worktop.
  2. We cut away the old sealant and clean off what’s left.
  3. Mould is treated, then the joint is left to dry thoroughly.
  4. Any bath is filled with water, then we lay a bead of anti-fungal silicone in white, clear or a matching colour.
  5. The joint is finished neatly and we explain when it can get wet.

How to prepare

  • Keep children and pets away from the work area
  • Tell us about access, such as stairs, a lift or high-level joints
  • Let us know about earlier repairs to the joints

How to get a quote

To get a quote, email us at info@mrmastic.co.uk with the location and a short description of the problem. We will give you a clear price before any work starts.

Get a quick quote

Read more

Landlord and commercial work in Corran

Water getting past a failed joint can damage the building, which matters even more when someone else lives there. Resealing at the right time is simple maintenance that we can handle for you.

We also work for property managers and facilities teams. We can quote a run of properties together, and we are fully insured for the work.

20+ yearsMastic and sealant specialists
ARBOMaster approvedApproved applicator for Arbo sealants
Fully insuredDomestic, commercial and hotels
One-year guaranteeOn every job