Hertfordshire · England
Bullsmoor Fire Rated Sealant
Problem with your fire-stopping gaps in Bullsmoor? We remove the old material, prepare the joints and seal them properly, with a 12-month guarantee.
- New service routes left unsealed after building work
- Cracked or shrunken fire-rated sealant
- Door frames with gaps between frame and wall
Looking after it afterwards
Once the sealant has cured, a few habits help it last:
- Don’t paint over fire sealant until it has cured
- Take pictures of fire stopping before ceilings or boxing go back
- Look in service cupboards and ceiling voids from time to time
- Don’t fill fire-stopping gaps with ordinary foam or silicone
Keep the record we give you with the building’s fire safety documents. It helps whoever checks the building next.
Small gaps around services are simple to deal with while there are only a few. Over time, more work adds more holes.
About our fire rated sealant in Bullsmoor
Where services or frames pass through a fire-resisting wall or floor, the gap around them needs a fire-rated seal. We apply intumescent and fire-rated sealants to the manufacturer’s tested details for each gap. We work on service penetrations, plasterboard & masonry and door frames, and common reasons people get in touch are joints picked up in a fire-stopping survey and open gaps behind door architraves.
For a pub, café, guest house or shop in or near Bullsmoor, its washrooms and kitchen need the same sealant care as any big building.
We stand behind the work with a one-year guarantee, so you are not left on your own once the job is done.
- Location
- Bullsmoor (EN3, EN1, EN8)
- Region
- Hertfordshire
- Guarantee
- 12 months on all our work
- Price
- A clear quote up front
- Phone
- 0345 464 0079
- Last updated
- 26 October 2026
When something else is needed
Some problems need a builder, plumber or other trade rather than us:
- Problems with the door itself rather than the gap around the frame
- Sign-off of the building, which sits with building control or your assessor
- Big openings where sealant alone isn’t the tested solution
Not sure which it is? You can call 0345 464 0079 or drop us an email and we’ll tell you honestly before booking.
What we seal
- Flats & HMOs
- Door frames
- Linear gaps
- Pipe & cable gaps
- Plasterboard & masonry
- Service penetrations
Commercial buildings in Bullsmoor
Workplaces and the common parts of blocks of flats in England need a fire risk assessment under the Regulatory Reform (Fire Safety) Order 2005, and gaps around services are often picked up there. We work to the specification you are given, installing the product to its tested details.
Schools such as Honilands Primary School are buildings too, and fire-stopping around service openings should be restored whenever new services go in. Community buildings like St George's Church are part of the picture too: service openings in its walls need the right fire-rated sealant, as in any building.
Bullsmoor is about 2 miles north-east of Enfield, in Hertfordshire. Our applicators cover fire rated sealant for homeowners, landlords and businesses in Bullsmoor and nearby, as part of our work across Hertfordshire. Our Hertfordshire coverage runs to 381 places, Bullsmoor among them. There’s also a page for London, about 12 miles away.
Postcode districts we cover here for fire rated sealant: EN3, EN1 and EN8. Local streets include Capel Road, Unity Road and Kempe Road, and we cover them all. Main roads around Bullsmoor include the M25, which makes travel easy. If you are just outside Bullsmoor, we cover Bulls Cross (1 mile west), Enfield Wash (1 mile south-east), Freezywater (1 mile east), Enfield Highway (1 mile south) and Enfield Lock (1 mile south-east). Further out, we also cover Watford (15 miles west), St Albans (13 miles north-west), Welwyn Garden City (11 miles north-west), Hoddesdon (6 miles north), Hatfield (10 miles north-west) and Hertford (9 miles north).
Local landmarks in Bullsmoor
Around Bullsmoor, our work takes us to homes and buildings near The Pied Bull Public House, The Lea Valley Academy and Gunpowder Park. There’s a railway station in Bullsmoor itself: Turkey Street station. Well-known places in the area include St Michaels Hospital (1.9 miles south-west) and Edmonton Green Shopping Centre (3.6 miles south). For a walk, there’s Ainslie Wood and Lippitts Hill.
How the job changes by surface
Plasterboard walls
Holes in plasterboard are often cut roughly for services. Gaps that are too big for sealant alone need a different detail.
Linear gaps
Head-of-wall gaps are often hidden above suspended ceilings. We work along the whole run leaving no stretch unsealed.
Nearby places to Bullsmoor
Other services in Bullsmoor
DIY versus a professional finish
Some sealant jobs are within reach of a careful DIYer, such as a straightforward joint indoors. The common mistakes are sealing over old sealant, sealing a damp joint and using far too much.
The difference is mostly in the preparation and the product. We take joints back to clean, dry surfaces, and the sealant is chosen for how the joint moves and where it is, then guaranteed for a year.
How the visit works
Our applicators work methodically: protection first, then preparation, sealing and a tidy-up. For most jobs that takes a few hours for a handful of gaps, and longer for a whole building. Parking around Bullsmoor is usually easier than in a town centre, but mention any lanes, gates or long drives. For outside work, side access and the height of the joints help us plan.
- We begin by agreeing the list of gaps from your assessor’s or designer’s requirements.
- We measure every gap and note what it’s in and what passes through.
- Any non-fire-rated filler is removed.
- The specified fire-rated sealant goes in over any backing its detail requires.
- We hand over a list of locations and products.
Before we arrive
- Keep children and pets away from the work area
- Let us know about stairs, lifts or work at height
- Tell us about any water getting in
Getting a quote
Call for a quick quote, or email us if that’s easier. Describe what needs sealing and we’ll explain what’s involved and give you a clear quote.
Read more
Bullsmoor: your questions answered
Can you help a landlord with a rental near Turkey Street station?
Yes. We work for letting agents and landlords as well as householders. You can call 0345 464 0079 or send us an email with the details for a clear quote.
Will you come out to Bullsmoor?
Yes, Bullsmoor is covered. Our work covers London and the South East, and smaller places are part of that. Longer journeys are simply planned in advance.
What does fire rated sealant cost?
It depends on the job, so we quote each one individually. For a quick quote, phone 0345 464 0079 or email us with a short description of the job.
Are you fully insured?
Yes. We are fully insured.
Can you quote for more than one area?
Yes. Just list everything you need and we will quote it together.
Do you guarantee your work?
Yes. Every job comes with our one-year guarantee.
Where are you based?
We are a Crawley-based firm. We work across South East England, London and Scotland.
Is standard sealant good enough for a fire gap?
No. It looks sealed but won’t perform as fire stopping. Use a product tested for that gap and service and we can apply it for you.
Quotes for fire rated sealant in Bullsmoor
Your quote is based on your job. We take into account:
- How much old sealant there is and how hard it is to remove
- Which sealant suits the joint
- The size of the job
- Access and height
The cost reflects the work involved, not guesswork. That’s why we ask about the job first.
Helping us quote
You do not need to know the technical terms. It helps if you can tell us:
- What’s wrong with the joints now
- A few photos by email, if you can
- Where the property is
- The rough size of the job
There’s no standard price list. Instead, your job gets its own clear quote. To get started, ring 0345 464 0079 or email us.
What we’re called out for in Bullsmoor
Many open fire-stopping gaps are made after the building is finished. Electricians, plumbers and data installers drill through walls and ceilings and the hole round the new service is not always sealed again.
Look out for these signs:
- Open holes round services passing through fire walls
- Damaged fire sealant left by other trades
- Gaps left after a refit or conversion
- Fire seals that have cracked with movement
If you let a flat or house near Turkey Street station, fire-rated sealant around pipes and cables through walls and floors needs making good whenever new services go through.
Comparing quotes
- Whether they seal over old material or remove it
- Which sealant they’ll use, and why
- Who does the work, and how experienced they are
- Whether you can choose the colour