Hampshire · England
Glazing Silicone in Burley Street
Glazing silicone for conservatories, rooflights, glass panels and shower screens in Burley Street, with a one-year guarantee on every job. Call for a quick quote.
- Stained, discoloured glazing silicone
- A quick top-up bead that didn’t last
- Rooflight joints letting water in
Leave it or put it right?
Dealing with a leaking shower screen early protects the floor and ceiling. A small leak can reach the floor below before you notice. In a small place like Burley Street, homes can be exposed to wind and rain, which finds any gap, and damp in older walls is slow to dry out.
Instead of a standard rate, we price the job in front of us: the amount of work, the old material and the access. The price is agreed before we begin.
Why choose Mr Mastic in Burley Street
- Experience in homes, commercial sites and hotels
- An ARBOMaster approved applicator
- Fully insured
- Any old sealant cut out fully, not covered over
How we handle glazing silicone in Burley Street
A frameless shower screen depends on its silicone. The joint down the wall and the one along the tray are common leak points, and we reseal both. Common call-outs are for a quick top-up bead that didn’t last and leaks from the base of a shower screen, across rooflights, glass balustrade bases and glass-to-glass joints.
Somewhere as small as Burley Street, older homes often have timber frames set in stone or brickwork. Older buildings like these do not always suit modern silicone, and sometimes a traditional sand mastic is the better choice.
All our work comes with a one-year guarantee, wherever you are in Hampshire.
- Where
- Burley Street (BH24)
- Wider area
- Hampshire
- Guarantee
- One year on every job
- Quotes
- A clear price before any work starts
- Telephone
- 0345 464 0079
- Updated
- 26 October 2026
How it works
Good joint work is mostly preparation, so that is where we spend the time. Joints are cleaned back and dried before anything new goes in. In total, it usually takes a few hours for most jobs. In a small place like Burley Street, access is generally the main thing to plan. If the job is outside, mention outbuildings, exposed walls and how to reach them.
- We find where water is getting in and check whether it’s a sealant joint.
- Old silicone is cut away from the glass and frame without scratching either.
- The glass and frame are cleaned and degreased.
- Glazing silicone suited to the joint is applied and tooled.
- We check the joints and, where safe, run water over them.
Preparing for the visit
- Mention any sign-in or site rules at work premises
- Where the joints are inside, avoid wetting them before we arrive
- Clear items away from the joints we are working on
Ask for a quote
For a quote, ring 0345 464 0079 or drop us an email and tell us where the job is and what the problem looks like. You will have a clear quote before any work starts.
Related advice
Landlords, agents and businesses in Burley Street
In hotels, rooms out of use cost money, so the work can be planned room by room around your bookings where we can. We’ve worked in hotels as well as homes and businesses.
Housing providers, facilities teams and property managers book us too. We can quote a run of properties together, and we are fully insured for the work.
Can I do it myself?
The difference is mostly in the preparation and the product. Joints are cleaned back to sound surfaces and dried, and the sealant is matched to the joint and its conditions, then guaranteed for a year.
Too much sealant is as bad as too little. A thick, smeared bead looks untidy and does not move well, and getting the depth right matters as much as the look.
Signs you need glazing silicone in Burley Street
Shower screen silicone gets wet every day. Mould grows into the bead and the joint starts to lift.
Most people get in touch when they notice something like this:
- Black or yellowed silicone on glass joints
- Shower screens leaking along the wall or tray
- Silicone pulling away from the glass
- Glass-to-glass joints that have split
Avon Tyrrell House, about 2.7 miles south-west, is one of the historic houses in the wider area around Burley Street.
What to look for in a quote
- How long to leave it before use
- Which colour the sealant will be
- What the quote includes, VAT included or not
- How the surfaces are prepared before sealing
What sealant work can’t fix
To be straight with you, there are a few things sealant will not fix:
- A sealed unit that has misted inside
- A broken pane or roof panel
- Rotten or badly damaged frames
If you are not sure, just phone 0345 464 0079 or email us and we will give you a straight answer before you book.
What we seal
- Rooflights
- Conservatory frames
- Glass balustrade bases
- Shower screens
- Glass-to-frame joints
- Glass-to-glass joints
Aftercare tips
Aftercare is simple:
- Stick to mild cleaners on glass
- Open vents or windows to let moisture out
- Act on drips or damp patches early
- Avoid scraping close to the bead
Do not use blades or scrapers near the bead when you clean. Stick to a soft cloth.
Do not leave lifting or mouldy silicone on glazing. Once it starts to peel, water gets behind it and the leak gets worse.
Windows and doors in Burley Street
Rainfall in the South East is lower than in much of the UK, though outdoor sealant still has to go onto a dry joint, so the forecast decides the day. Historic houses like Avon Tyrrell House (about 2.7 miles south-west) are a reminder that the area around Burley Street has older buildings as well as new. In older buildings, older frames set in brick or stone need a sealant that suits them, and sometimes that is traditional sand mastic.
If you look after a building such as Burley Primary School, its window and door frames need their mastic kept sound, just like a home’s.
Burley Street is in Hampshire. Wherever you are in the BH24 postcode area, we cover glazing silicone for homes and businesses. Burley Street is one of 683 towns and villages in Hampshire where we work. Our Southampton page covers work nearby (15 miles or so).
We work across BH24 for glazing silicone and the streets around it. Whether your property is on Tyrells Lane, Ringwood Road and Forest Road or a nearby road, we can help. Close by, we work in Burley (1 mile south-east), Foulford (2 miles north-west), Forest Corner (2 miles north-west), Shobley (2 miles north-west) and Bagnum (2 miles south-west). Larger places within reach include Totton (11 miles north-east), Lymington (9 miles south-east), Romsey (15 miles north-east), Hythe (14 miles east), New Milton (6 miles south) and Ringwood (3 miles west).
Near you in Burley Street
We work in homes and buildings around The Queen's Head pub and the streets around them. The countryside around Burley Street includes Linbrook Lake and Blashford Lakes.
Also in Burley Street
FAQs for Burley Street
What guarantee comes with glazing silicone in Burley Street?
Every job comes with our 12-month guarantee, wherever it is. We are fully insured, and an ARBOMaster approved applicator.
Is Burley Street within the area you cover?
Yes, Burley Street is covered. Our work covers London and the South East, and smaller places are part of that. Longer journeys are simply planned in advance.
Where do you work from?
Our base is Crawley, with over 20 years’ experience. Our area covers South East England, London and Scotland.
Can I do it myself?
For a simple, easy-to-reach joint, a careful DIYer can do a reasonable job. Most DIY failures come from sealing over old material, wet joints or too much sealant.
Can you do several jobs on one visit?
Yes. Just list everything you need.
What sealant do you use?
Products from Arbo and Everbuild, among others, chosen to suit the joint. We explain the product when we quote.
Are you insured?
Yes. We are fully insured for every job we do.
Is there any odour?
That depends on the sealant. Some smell for a while, some hardly at all.