Isle of Wight · England
Fire-rated sealant in St Lawrence, Isle of Wight
Fire rated sealant across St Lawrence and nearby, with old sealant always removed completely.
- Sealant items on a fire risk assessment action list
- Gaps left after a refit or conversion
- Damaged fire sealant left by other trades
About our fire rated sealant in St Lawrence
A fire seal relies on being installed the way it was tested: the right depth, the right backing and the right product for the substrate. That is the part we focus on, gap by gap. If you’re dealing with gaps flagged on a fire risk assessment and ordinary sealant used where a fire-rated product was needed, we can put it right, on service penetrations, flats & HMOs and linear gaps alike.
In a village or hamlet like St Lawrence, commercial work is more likely to be a pub, a farm shop, holiday lets or a village hall than an office block. Each still needs sound sealant in its washrooms and kitchens, and fire-rated joints where services pass through walls.
Big or small, you get the same one-year guarantee.
- Location
- St Lawrence (PO38)
- Region
- Isle of Wight
- Guarantee
- 12 months on all our work
- Quote
- Quoted before any work starts
- Phone
- 0345 464 0079
- Last updated
- 26 October 2026
Commercial buildings in St Lawrence
For seaside hotels, guest houses and holiday lets around St Lawrence, heavy use in the busy months is hard on washroom and kitchen sealant, and any building work there should leave fire-rated joints made good. Workplaces and the common parts of blocks of flats in England need a fire risk assessment under the Regulatory Reform (Fire Safety) Order 2005, which is often where open fire-stopping gaps are first noticed. We work to the specification you’re given, installing the product to its tested details.
For landlords with property near Shanklin station, new cables or pipes through a fire-resisting wall leave a gap that needs the right sealant. Community buildings like St Lawrence's Church are part of the picture too: service openings in its walls need the right fire-rated sealant, as in any building.
St Lawrence is about 4 miles south-west of Shanklin, in the Isle of Wight. Jobs in St Lawrence get the same care as everywhere else we work: old sealant removed completely, careful preparation and a one-year guarantee. Our the Isle of Wight coverage runs to 125 places, St Lawrence among them. There’s also a page for Portsmouth, about 17 miles away.
Here we cover the PO38 postcode area for fire rated sealant. You’ll find streets such as Twining Road, Whitwell Road and Woolverton Road, and we cover them all. If you’re just outside St Lawrence, we cover Steephill (1 mile east), Nettlecombe (1 mile north-west), Whitwell (1 mile north-west), Ventnor (1 mile east) and Bierley (2 miles north-west). Larger places within reach include Newport (8 miles north), Ryde (10 miles north), Cowes (12 miles north), Sandown (6 miles north-east), Shanklin (4 miles north-east) and East Cowes (12 miles north). If you’re somewhere remote, the job takes a little more planning, so mention it when you ask for a quote.
Landmarks near St Lawrence
Locally, jobs take us to homes and businesses close to St Catherine's School. For rail, the closest station is Shanklin station, roughly 4.1 miles north-east of the centre. A little further out are Arthur Webster Memorial Hospital for Children (4.1 miles north-east) and Longshoremans Museum (1.3 miles east). The countryside around St Lawrence includes Stenbury Down.
Also in St Lawrence
Why deal with it now?
Fire-rated sealants need more care than everyday sealant. Depth, backing and surface preparation all affect how a seal performs, and we work to the product details every time. In a small place like St Lawrence, homes can be exposed to wind and rain, which finds any gap, and older walls, once damp, take a long time to dry.
There are no prices on our website, because the cost depends so much on the job itself. For a quick quote, please phone 0345 464 0079 or drop us an email and we’ll talk you through it.
Why book with us
- 180+ five-star Google reviews
- Quality sealants from Arbo and Everbuild
- We never seal over old sealant
- More than 20 years in sealant work
Read what affects the cost and our reviews.
FAQs for St Lawrence
Do you take on hotel work around St Lawrence?
Yes, hotels and guest houses are among the places we work. A room-by-room programme keeps most rooms in use while the work goes on.
Do you cover smaller places like St Lawrence?
Yes. St Lawrence is within the area we cover, which takes in towns, villages and rural addresses. We work across London and the South East. Let us know about access, parking and anything unusual about getting there when you book.
Does someone need to be in?
That depends on where the joints are. Inside work needs someone to give us access.
Do you have insurance?
Yes. We’re fully insured for every job we do.
What fire rating will the seal have?
We do not issue ratings or certificates ourselves. What’s required is set by your assessor or designer, and the product’s tested details show what it achieves; we install to those details and record what we did.
What information do you need?
The location, the problem and the rough size of the job. If you can, email a few photos.
Is it OK to seal over old sealant?
No, because it fails. The old sealant always comes out first.
Can I add another job to the visit?
Yes, we can. Several rooms, windows or areas can go on one quote.
What we’re called out for in St Lawrence
Door frames are a common weak spot. The gap between the frame and the wall is hidden behind the architrave, so it can be left open when a door is replaced.
It’s worth asking for a quote if you see:
- Damaged fire sealant left by other trades
- Standard silicone or caulk in a fire-stopping gap
- New service routes left unsealed after building work
- Door frames with gaps between frame and wall
Managing a site like St Francis Catholic and Church of England Primary Academy? Then gaps opened by contractors for new cabling are a common finding in schools and offices.
What your quote should include
- How the joint is cleaned and prepared
- How the colour is chosen
- What guarantee comes with the work
- What happens if they find a problem under the old sealant
For landlords and businesses
From a single let to a portfolio, you get the same standard of work: old sealant fully removed, joints prepared properly and a one-year guarantee.
Failed sealant is one of the commonest items on a check-out report, and it’s easy to sort out between tenants. Several properties can be quoted together.
Looking after it afterwards
Looking after new joints is easy:
- Tell trades working in the building that fire seals must be put back
- Check risers, ceiling voids and cupboards during building checks
- Keep general-purpose foam and caulk away from fire-stopping gaps
- Include fire stopping when you schedule refits
Look at the sealed gaps as part of your routine walk-rounds. Look for cracks, gaps or sealant that has been cut or pulled out and get them seen to.
Any job that breaks through a wall or ceiling should include resealing. Catching it then saves a separate visit later.
How the job changes by surface
Door frames
Frame gaps are normally hidden behind the architrave. We seal any open gap to the product’s tested details.
Masonry and concrete
Brick, block and concrete walls and floors are sealed with products tested in masonry. We clean out dust and debris before sealing.
The process
We keep the work tidy and contained to the area we’re working on, so you can get on with your day. The job usually takes from a few hours to a few days, depending on the number of gaps and the access, and we explain the cure time before we leave. Somewhere like St Lawrence needs a little journey planning: tell us about narrow lanes, gates, long drives and where we can park. Everything for the job comes with us, so a second trip is avoided where possible.
- Before starting, we go through the specification or action list with you.
- We measure every gap and note what it’s in and what passes through.
- Any non-fire-rated filler is removed and the faces cleaned.
- The specified fire-rated sealant goes in over any backing its detail requires.
- We hand over a list of locations and products for your records.
How to prepare
- Clear items away from the joints we’re working on
- Mention if the joints have been sealed before
- Try not to wet indoor joints just before the visit
Getting a quote
Quotes start with a quick conversation. Describe the problem, the location and the size of the job, and we will talk you through what we’d do. Whenever you are ready, call 0345 464 0079 or drop us an email.
Advice
How we quote for fire rated sealant
The quote reflects the job in front of us. We look at:
- Access and height
- The amount of work
- Mould in or behind the old joints
- The product the joint needs
Commercial jobs are quoted on the same basis as homes: the amount of work, how we reach it and what it needs, plus any working-time requirements on site. Ask us for a quote and we will explain what it covers.
Asking for a quote
You do not need to know the technical terms. Just tell us:
- Access, such as stairs, a lift or height
- Any previous sealing or DIY work
- The type of property
- A few photos by email, if you can
For a quick quote, get us on the phone, or send an email if you’d rather. Tell us about the joints that need doing and we will talk you through the work and give you a clear quote.