Aberdeenshire · Scotland
Remedial Sealant in Fraserburgh
Problem with your failed sealant joints in Fraserburgh? We remove the old material, prepare the joints and seal them properly, and the work is guaranteed for a year.
- Sealant peeling off a dusty or damp surface
- Wide, uneven beads that look worse than the old ones
- Repeat leaks from the same joint
Remedial sealant around Fraserburgh
Fraserburgh is close to the coast. Near the coast, holiday lets and guest houses can see bathrooms used by one guest after another, and sealant and grout that work that hard wear out sooner. Scotland’s water is generally soft, so sealant and grout see less limescale than in much of England. Mould is another matter: a bathroom that stays damp still turns sealant and grout black.
If you look after a building such as Fraserburgh Academy, its toilets, changing areas and kitchens need their sealant renewed like any other building’s.
Fraserburgh is about 37 miles north of Aberdeen, in Aberdeenshire. Wherever you are in the AB43 postcode area, our applicators can take on remedial sealant. Our Aberdeenshire coverage runs to 161 places, Fraserburgh among them. For nearby work, see our Aberdeen page.
Postcode districts we cover here for remedial sealant: AB43. Remedial sealant is available to properties on High Street, Main Street and Thompson Terrace. Fraserburgh sits on or near the A90 and A98, so getting to you is simple. Neighbouring places we cover for remedial sealant include Broadsea (1 mile north), Sandhaven (2 miles north-west), Pittulie (2 miles north-west), Memsie (3 miles south-west) and Inverallochy (3 miles east). Within a short drive, we also cover Peterhead (15 miles south-east), Roanheads (15 miles south-east), Clerkhill (15 miles south-east), Port Henry (15 miles south-east), Mintlaw (11 miles south) and Longside (12 miles south). Fraserburgh is one of the larger places we cover in Aberdeenshire.
Landmarks near Fraserburgh
Typical jobs here are in homes near The Saltoun Inn and the streets around them. Other landmarks nearby include Fraserburgh Hospital (within half a mile north) and Fraserburgh Heritage Centre (0.9 miles north-east).
Remedial sealant in Fraserburgh
The wrong product in the wrong joint fails however neatly it’s applied. Out it comes, and in goes a sealant suited to the job. If you’re dealing with kitchen joints letting water behind the worktop and leaks that keep coming back after resealing, we can put it right, on failed movement joints, botched or over-sealed joints and expansion joints alike.
Scottish water is generally soft, so homes in a town like Fraserburgh see less limescale than many parts of England. Mould is a different story: a steamy bathroom still turns sealant and grout black.
Our work is backed for twelve months.
- Place
- Fraserburgh (AB43)
- Region
- Aberdeenshire
- Guarantee
- A year, on every job
- Quote
- Quoted before any work starts
- info@mrmastic.co.uk
- Last updated
- 26 October 2026
Landlords, agents and businesses in Fraserburgh
For anyone letting property in or around Fraserburgh, several properties can be quoted together. Just tell us the addresses and what each one needs, and photos by email help.
We work for landlords and agents as well as homeowners. Resealing between tenancies keeps a property looking cared for before the next move-in.
Towns and villages near Fraserburgh
What else we do in Fraserburgh
What the job involves on each surface
Windows & doors
Wrong-coloured or messy mastic can be replaced for appearance too, matched to the frame colour.
Over-sealed & botched joints
A botched joint can hide two or three layers of sealant, including the smears and film on surrounding tiles. New sealant needs a fully clean surface.
Questions from Fraserburgh
Do you cover Fraserburgh for remedial sealant?
Yes, Fraserburgh is within the area we cover. Our work covers the whole of Scotland. Just drop us a line at info@mrmastic.co.uk with a few details of the job.
Is there a guarantee on remedial sealant in Fraserburgh?
Every job comes with our 12-month guarantee, wherever it is. We are also fully insured and ARBOMaster approved.
Is there any odour?
That depends on the sealant. Some products have a noticeable smell, others very little, and any smell fades as they cure.
What information do you need?
Let us know what needs doing and where. We’ll ask anything else we need to know.
What sealant do you use?
Quality sealants from brands including Arbo and Everbuild, picked for each joint. We will tell you what we’re using and why.
Is it worth trying it myself?
For a simple, easy-to-reach joint, a careful DIYer can do a reasonable job. Most DIY failures come from sealing over old material, wet joints or too much sealant.
Do you remove the old sealant?
Always. Sealing over old sealant is the main reason resealing fails early, so we never do it.
Can old silicone be taken off without scratching the tiles?
Yes. We avoid heavy scraping and use the right cleaner for each surface, so the new sealant bonds cleanly.
Keeping the joints in good condition
Once the sealant has cured, a few habits help it last:
- Keep the room well ventilated
- Don’t wait for a small gap to become a leak
- Check trays and worktops do not move
- Keep movement joints clear of mortar and paint
Watch the joint over the first few weeks, particularly where the original failure was caused by movement. Should anything change, send an email to info@mrmastic.co.uk.
Don’t keep resealing the same joint. Get the cause found first, or the next bead will go the same way.
Signs you need remedial sealant in Fraserburgh
How a joint is built matters as much as the product. A bead bonded on three sides, or laid too thick, cannot flex, so it tears when the joint moves. Backing sets the depth and stops that.
Keep an eye out for any of the following:
- Repeat leaks from the same joint
- Over-sealed joints coming away
- Wide, uneven beads that look worse than the old ones
- Mould trapped under a layer of silicone
Around Fraserburgh, as everywhere, remedial sealant is only as good as the preparation behind it.
What to look for in a quote
- How the surfaces are prepared before sealing
- Which colour the sealant will be
- Whether they’re fully insured
- Is the old sealant removed completely?
What affects the quote in Fraserburgh
We quote each job individually. This is what makes a difference:
- Access and height
- Whether old sealant or filler has to be cut out
- The number of rooms or windows
- Whether there’s mould to deal with
Combining jobs into one visit is usually more efficient than separate visits. We will send you a clear quote for the lot.
What we need to know
Photos help, but a description is a good start. Try to tell us:
- Any previous sealing or DIY work
- Access, such as stairs, a lift or height
- What’s wrong with the joints now
- Where the property is
For a quote, drop us a line at info@mrmastic.co.uk with the location and a short description of the problem. You’ll have a clear quote before work begins.
What we do, step by step
You don’t need to clear the whole room or building before we come, just the space around the work. We protect the rest, and the work takes a few hours for a typical bath or shower, longer where several layers have been applied in most cases. A visit in Fraserburgh needs three things planned: access, parking and where the work is. Outside work depends on the weather, as sealant needs a dry surface.
- First we work out whether the problem is the sealant, movement or a leak.
- Each layer is cut out and the residue cleaned off.
- Mould is treated and the joint dried.
- We reseal with a product suited to the joint, backed where needed.
- We finish neatly and point out anything that needs another trade.
Preparing for the visit
- Mention if the joints have been sealed before
- Clear the area around the work
- On commercial sites, let us know about site rules
How to get a quote
We don’t publish a price list, because every job is different. Instead, your job gets its own clear quote. To get started, email us at info@mrmastic.co.uk.
Related advice
What sealant work can’t fix
We will always be straight with you, so here’s what new sealant will not do:
- Movement from fittings that aren’t supported
- Older mastics that may need an asbestos check before removal
- A tray or bath that’s cracked
If in doubt, email us at info@mrmastic.co.uk and we will say what we think.
Where we work in Fraserburgh
- Expansion joints
- Mouldy bath & shower sealant
- Botched or over-sealed joints
- Leaking tray & enclosure joints
- Shrunken worktop sealant
- Failed movement joints