Highland · Scotland
Dalmore Gutter Sealing
Gutter sealing for Dalmore, by sealant specialists with 20+ years’ experience. 180+ five-star Google reviews and a 4.9 rating.
- Water running down the wall below the gutter
- Quick sealant fixes on gutters that didn’t last
- Trim joints where the sealant has failed
About our gutter sealing in Dalmore
It’s easy to live with a dripping gutter joint, but the water lands on the same spot every time it rains. Resealing it is a small job if the gutter is otherwise in good order. If you are dealing with old sealant on roofline trims that has split and stop ends leaking at the end of a run, we can help.
In and around a place like Dalmore, many buildings face open ground and take the full weather. Gutter joints and wall joints take a battering.
You are covered for a year from the day we finish. If there’s a problem with it, please email us at info@mrmastic.co.uk.
- Place
- Dalmore (IV17)
- Wider area
- Highland
- Cover
- A year, on every job
- Quote
- Quoted before any work starts
- info@mrmastic.co.uk
- Updated
- 26 October 2026
How to look after the new joints
So the new joints stay in good condition:
- Make sure downpipes are not blocked
- Sort out a dripping joint early
- Look at the gutters while it’s raining
- Keep an eye out for wet patches below a joint
Look at fascia and trim joints when you are checking the gutters. Splits are easier to seal early.
Leaking gutter joints get worse over time. The same spot gets soaked every time it rains, which can lead to staining and damp.
Places near Dalmore
What else we do in Dalmore
DIY versus a professional finish
A careful DIYer can reseal a simple joint, like a short, easy-to-reach joint indoors. The common mistakes are sealing over old sealant, sealing a damp joint and using far too much.
If you do try it yourself, take your time over the preparation: take out all the old sealant, make sure the joint is clean and dry, and give it the full cure time. If it fails, we can still redo it.
What the job involves on each surface
Garage door frames
Resealing a garage door frame keeps rain and draughts out.
Gutter joints
A dripping joint doesn’t always mean a failed gutter. Resealing is normally enough.
Leave it or put it right?
A new garage door is not needed for a leaking frame. Sealing the frame normally stops it. When the nearest tradesperson is a drive away, it’s tempting to leave a small leak, but water behind a failed seal does the most damage when nobody’s watching.
Commercial jobs are quoted on the same basis as homes: the amount of work, the access and the products needed, along with when we can work on site. Ask us for a quote and we will explain what it covers.
What you get with us
- Every job guaranteed for a year
- Domestic, commercial and hotel work
- Over 20 years’ experience
- Old sealant always removed completely
Take a look at how sealant jobs are priced or what customers say.
Dalmore questions
Does the coastal weather in Dalmore affect outside sealant?
Coastal homes put outside sealant through more weather than inland ones, so the choice of sealant and the preparation matter even more. Walls facing the sea are generally the first to need attention.
Will you come out to Dalmore?
Yes, we do. Our work covers the whole of Scotland, and smaller places are part of that. The journey is planned ahead, so it helps to know about access.
Can you work on commercial sites?
Yes. We can plan bigger jobs in stages.
Is it messy?
Tidy work is part of the job. Nearby surfaces are protected, and we clear up when we’re done.
Is it worth trying it myself?
It depends on the job. High-level, external movement and fire-rated joints are professional jobs, while a short indoor joint may be within reach.
Is sealant enough for a gutter that has dropped?
Not for long. The movement opens the joint again, so the fall and brackets need sorting first.
Do you remove the old sealant?
Yes. All of the old material is cut out and the joint cleaned.
How long will you be here?
Typically it takes an hour or two for a few joints, longer for a full run. Bigger jobs take longer, and we’ll tell you how long to expect.
How the visit works
A visit follows a simple pattern: we look at the joints together, protect the area around them, do the work and tidy away. It usually takes an hour or two for a few joints, longer for a full run. In smaller Scottish places, parking is usually less of an issue than access and distance. Tell us how to find the property and how to reach the work.
- First we trace the drip and check the gutter is not damaged.
- We remove the old sealant and clean the joint.
- The joint is dried before sealing.
- We seal the joint with a sealant made for gutters.
- The gutter is checked and debris around the joints cleared.
Getting ready for the visit
- For indoor joints, keep the area dry beforehand if you can
- Mention if the joints have been sealed before
- Keep children and pets away from the work area
Getting a quote
We don’t publish a price list. Instead, we give you a clear price for your job. To arrange one, email us at info@mrmastic.co.uk.
Read more
What we cannot put right
Before you book, it’s worth knowing the limits too:
- Problems with the roof covering
- Guttering that needs replacing
- Rotten or damaged fascia boards
If in doubt, send an email to info@mrmastic.co.uk and we’ll say what we think before you book.
Where we work in Dalmore
- Roofline trims
- Garage door frames
- Gutter joints
- Gutter end caps
- uPVC fascias
- Soffit joints
Landlords, agents and businesses in Dalmore
In hotels, rooms out of use cost money, so we plan the work room by room around your bookings where we can. Hotel work is part of what we do, alongside homes and businesses.
Mouldy or split sealant often shows up at the end of a tenancy, and it’s quick to put right between tenancies. We can quote for more than one property at once.
Gutter sealing in Dalmore: local notes
Dalmore is within about 1 mile of the coast, and homes near the sea take more wind-driven rain, with salt in the air closer to the shore. That is hard on gutter, fascia and roofline joints, especially on the side facing the sea. Historic houses like Novar House (about 3.2 miles west) are a reminder that the area around Dalmore has older buildings as well as new. In older buildings, older walls and rooflines need a sealant that moves with them and suits the material.
If you let a flat or house near Alness station, leaking gutter joints on a rental are best caught before they stain the walls. Homes close to Rosskeen Parish Church include some older properties, and an extension built onto an older house moves differently, and the joint between them takes the strain. If you look after a building such as Alness Academy, its movement joints, gutters and trims need looking after like any other building’s.
Dalmore is about 15 miles north of Inverness, in Highland. Across the IV17 area, we cover gutter sealing for homes and businesses. 253 places in Highland are on our list, large and small.
All of IV17 is within our area for gutter sealing, from the main roads to the quietest streets. Dalmore sits on or near the A9. We also cover the places around Dalmore: Alness (1 mile north-west), Invergordon (3 miles east), Cullicudden (3 miles south), Saltburn (4 miles east) and Evanton (4 miles south-west). Within a short drive, we also cover Inverness (15 miles south), Cradlehall (15 miles south), Tain (11 miles north-east), Merkinch (14 miles south), Dingwall (9 miles south-west) and Dornoch (15 miles north-east). Island and remote addresses take a little more planning, so tell us where you are when you ask for a quote.
Local landmarks in Dalmore
Dalmore has its own railway station: Alness station. Nearby you will also find Contullich Castle (2 miles north-west) and County Community Hospital (3.3 miles east). Not far away are Cnoc Fyrish and Loch Achnacloich.