Kent · England
St Mary's Bay Gutter Sealing
Problem with your gutter and fascia joints in St Mary's Bay? We remove the old material, prepare the joints and seal them properly, with a 12-month guarantee.
- Stop ends leaking at the end of a run
- Internal damp traced to a gutter joint
- Gaps along fascia and soffit joints
The process
The work is kept neat and contained to the area we’re working on, so you can carry on as normal. Expect the work to take an hour or two for a few joints, longer for a full run, and we explain the cure time before we leave. Parking around St Mary's Bay is usually easier than in a town centre, but mention any lanes, gates or long drives. For outside work, side access and the height of the joints help us plan.
- We start by tracing the leak and checking the gutter itself is sound.
- The joint or trim is cleaned out and old sealant removed.
- We make sure the joint is dry before sealing.
- Gutter or exterior sealant is applied and finished.
- We look along the gutter and clear debris around the joints.
Preparing for the visit
- Tell us if parking is tricky
- Let us know if you’ve seen damp or leaks
- Mention any tricky access
Get a quote
Every job is quoted individually. Just phone 0345 464 0079 or send us an email with the details and send photos if you have them.
Related advice
Gutter sealing for homes and businesses in St Mary's Bay
A lot of gutter leaks come down to one tired joint. The joint is cleaned, dried and resealed using a gutter sealant. If the gutter itself has failed, we say so. If you’re dealing with gaps along fascia and soffit joints and old sealant on roofline trims that has split, we can put it right, whatever the surface.
In and around St Mary's Bay, older properties sit alongside newer ones, each with its own outside joints. Older homes need their gutter and trim joints kept tight, newer ones their movement joints.
We guarantee the work for a year. If something isn’t right with it in that time, tell us and we’ll put it right.
- Place
- St Mary's Bay (TN29)
- Wider area
- Kent
- Cover
- A year, on every job
- Price
- Quoted before any work starts
- Telephone
- 0345 464 0079
- Last updated
- 26 October 2026
Do you need gutter sealing in St Mary's Bay?
Water spilling over a blocked gutter is often mistaken for a leak. A blocked downpipe makes water back up so we check the cause first.
Any of these means the joints need attention:
- Damp patches inside below a leaking gutter
- Fascia boards with gaps between them
- Failed sealant on a garage door frame
- Wet patches on the wall under a gutter joint
For an older house near a landmark such as All Saints, old and new materials meet at the roofline and walls, which is where sealant earns its keep.
What your quote should include
- What insurance they hold
- The length of the guarantee
- What the cure time is
- What the quote includes, VAT included or not
What affects the quote in St Mary's Bay
For a quick quote, just ask. What matters most is:
- The size of the job
- Mould in or behind the old joints
- When we can work, for business premises
- Whether old sealant or filler has to be cut out
Combining jobs into one visit usually makes better use of the time than several visits, so tell us about everything that needs sealing. You will get one clear quote for the whole job.
What to tell us for a quote
A few details help us give you an accurate quote. When you get in contact, it helps to mention:
- What’s wrong with the joints now
- If it’s domestic, commercial or a hotel
- How many joints, rooms or windows are involved
- How we’d reach the joints
Want a quote for gutter sealing? Please phone 0345 464 0079 or send us an email with a few details. We’ll explain what we’d do and send you a clear quote before any work starts.
Common questions in St Mary's Bay
Does living near the coast affect gutter sealing in St Mary's Bay?
Coastal weather is harder on outside sealant: there’s more wind-driven rain and, closer to the shore, salt in the air. Choosing the right sealant for the frame and wall, laid at the right depth, helps it last.
Is St Mary's Bay within the area you cover?
Yes, smaller places are covered as well as towns. We work across London and the South East. Let us know about access, parking and anything unusual about getting there when you book.
Can you work on commercial sites?
Yes. Commercial and hotel work is a large part of what we do, as well as homes. Working times can be discussed when we quote.
What does gutter sealing cost?
There’s no set price, as it depends on the job: its size, the old material, access and the product needed. You will get a clear quote before any work starts.
Is sealing fascia joints something you do?
Yes. We seal open joints along fascias and soffits in a colour to suit.
Where do you work from?
We’re a Crawley-based firm. We work across South East England, London and Scotland.
What information do you need?
Only a few details: the address or postcode, what’s wrong and any access issues. After that, simply ring 0345 464 0079 or drop us an email.
How long will you be here?
Typically it takes an hour or two for a few joints, longer for a full run. Bigger jobs take longer, and we will say how long yours will take.
Nearby places to St Mary's Bay
More services for St Mary's Bay
DIY versus a professional finish
Some jobs are best left to a professional: high-level joints, fire-rated gaps, external movement joints and big jobs need the right product, the right access and the right method.
If you do try it yourself, take your time over the preparation: remove every trace of old sealant, clean and dry the joint, and follow the product’s cure time. If it fails, we can still redo it.
Landlords, agents and businesses in St Mary's Bay
We work for letting agents and landlords as well as householders. Sealant work between tenants keeps a property looking cared for before the next move-in.
We regularly work with letting and managing agents. Send the address, what’s needed and the access arrangements.
What gutter sealing looks like in St Mary's Bay
St Mary's Bay is within about 1 mile of the coast, where wind-driven rain is a fact of life and, nearer the shore, so is salt air. That is hard on gutter, fascia and roofline joints, especially on the side facing the sea. The South East is one of the drier parts of the UK, though outdoor sealant still has to go onto a dry joint, so the forecast decides the day.
For site and facilities teams at buildings such as The Marsh Academy, its movement joints, gutters and trims need looking after like any other building’s.
St Mary's Bay is about 6 miles south-west of Hythe, in Kent. St Mary's Bay gets the same service as everywhere we cover: the old material taken out, joints prepared properly and a 12-month guarantee. St Mary's Bay is one of 922 places in Kent where we work. For nearby work, see our Brighton page, about 50 miles away.
Jobs for gutter sealing in TN29 is quoted and booked the same way as anywhere else. We cover properties on Maple Drive, Oak Drive and Beechwood Close. If you are just outside St Mary's Bay, we cover St Mary in the Marsh (1 mile west), Burmarsh (3 miles north), Newchurch (3 miles north-west), Postling Green (5 miles north) and Bonnington (6 miles north). Larger places within reach include Ashford (10 miles north-west), Folkestone (10 miles north-east), Hythe (6 miles north-east), Hawkinge (11 miles north-east), Tenterden (13 miles west) and Cheriton (9 miles north-east).
What’s near St Mary's Bay
Locally, jobs take us to homes and businesses close to Romney Warren Country Park, among other places. Nearby you’ll also find Romney 'castle' (3.6 miles west).
What the job involves on each surface
Gutter end caps
Drips from a stop end run down the brickwork. It’s a small job to fix.
Gutter joints
A dripping joint doesn’t always mean a failed gutter. Resealing is generally enough.
Keeping the joints in good condition
Once the sealant has cured, a few habits help it last:
- Glance at the soffit joints now and then
- Make sure downpipes are not blocked
- Check the gutters during heavy rain
- Keep an eye out for wet patches below a joint
Keep the gutters clear of leaves and moss so water does not sit on the joints. Standing water strains every seal.
Early sealing limits how much water hits the wall. If we find a bigger problem, we’ll tell you.