Medway · England

Regrouting in Higham, Medway

Raking out old, cracked or stained grout and regrouting tiled walls and floors for householders, landlords and businesses in Higham. Fully insured, ARBOMaster approved and guaranteed for a year.

  • Corners filled with grout instead of silicone
  • Floor grout that will not come clean
  • Good tiles let down by tired grout

Regrouting near Higham

How we handle regrouting in Higham

Regrouting is normally paired with resealing. Grout belongs between tiles, but corners and edges move, so they’re sealed with silicone rather than grout. Renewing both together means nothing is left half-done. We’re often asked to deal with cracked grout along the bath or tray and old grout in a dated colour, on tiled floors, wet rooms and kitchen splashbacks.

Around Higham, it’s houses and cottages rather than flats. The work is the same as anywhere: old material cut out, joints cleaned and a fresh finish laid.

A one-year guarantee comes as standard, so you are covered after we have gone.

Mr Mastic applicator sealing the vertical joint between a glass shower screen and tiled wall
Location
Higham (ME3, DA12)
Wider area
Medway
Cover
One year on every job
Quote
Quoted before any work starts
Phone
0345 464 0079
Page updated
26 October 2026

How the job changes by surface

Wet rooms

Regrouting a wet room helps keep water on the surface of the tiles. It cannot fix waterproofing below the tiles.

Kitchen splashbacks

We can regroute a splashback with the kitchen left in place. The worktop edge is finished with silicone.

Keeping the joints in good condition

Good habits help new joints last longer. A few tips:

  • Use a squeegee on the tiles after showering
  • Keep harsh bleach and acid cleaners off the grout
  • Rinse soap off the tiles after each shower
  • Do not ignore a tile that feels loose

Before we leave, you’ll know when the shower can be used. Please follow it, and avoid scrubbing the new grout hard for the first few days.

Cracked grout does not stay cracked for long. Water gets in behind and the tiles can start to loosen and early regrouting can avoid a much bigger job.

How the visit works

Once we’re on site, we check the joints match what you told us. If anything is different, we explain it before carrying on. After that, the work takes a few hours for a shower enclosure, longer for a whole room. In a small place like Higham, access is usually the main thing to plan. For outside work, also let us know about exposed walls and any outbuildings involved.

  1. Every tile area is checked for hollow or loose tiles first.
  2. We rake out the grout evenly, protecting the tile edges.
  3. We vacuum the joints so the new grout bonds.
  4. We regrout the joints and clean the tile faces.
  5. Silicone goes into the corners and along the edges.

Getting ready for the visit

  • Clear items away from the joints we’re working on
  • Tell us about access, such as stairs, a lift or high-level joints
  • Keep pets and children clear of the area while we work

How to get a quote

For a quote, ring 0345 464 0079 or drop us an email and tell us where the job is and what the problem looks like. We will give you a clear price before any work starts.

Get a quick quote

Related advice

Signs you need regrouting in Higham

Some grout fails because it was mixed or laid badly. Grout that was too wet, not packed in or cleaned off too hard can wash out within a few years.

Look out for any of the following:

  • Crumbling grout between the tiles
  • Corners filled with grout instead of silicone
  • Greasy, stained grout behind the hob
  • Grout in a colour the owner wants to change

Homes close to Church of St John include some older properties, and timber floors under older bathrooms flex, so joints need a sealant that moves with them.

What your quote should include

  • How long to leave it before use
  • Whether they seal over old material or remove it
  • Are they insured?
  • What preparation is included

Choosing a sealant specialist

Work for landlords, hotels and businesses

From a single let to a portfolio, you get the same standard of work: the old material taken out, careful preparation and a 12-month guarantee.

We also work for property managers and facilities teams in Higham and across Medway. We can quote a run of properties together, and we are fully insured.

Regrouting in Higham: local notes

Most of the South East has hard water, so limescale builds up on sealant, grout and fittings.

Rented homes near Higham station change hands often, and stained grout drags a rental down, and regrouting between lets puts that right. Managing a site like Higham Primary School? Then its toilets, changing areas and kitchens need their sealant renewed like any other building’s.

Higham is about 2 miles north-west of Rochester, in Medway. Homes, rented property, offices and hotels in Higham is covered for regrouting, old or new, large or small. Every job comes with our one-year guarantee. Higham is one of 68 places in Medway where we work for regrouting. You can also see our page for Chelmsford, roughly 22 miles from Higham.

We cover every part of the ME3 and DA12 postcode area for regrouting and the streets around it. Whether your property is on Villa Road, Darby Gardens and Ash Crescent or a nearby road, we can help. Neighbouring places we cover for regrouting include Gadshill (1 mile south), Lower Higham (1 mile north), Shorne (1 mile west), Shorne Ridgeway (1 mile south-west) and Mockbeggar (2 miles east). Further out, we also cover Gillingham (6 miles south-east), Chatham (5 miles south-east), Rainham (8 miles south-east), Luton (5 miles south-east), Park Wood (8 miles south-east) and Lordswood (7 miles south-east).

Landmarks near Higham

In Higham, that means homes and buildings near Rede Common, Sir John Falstaff Public House and Strood Academy. The nearest railway station is Higham station, about 0.9 miles north-east. Well-known places in the area include Rochester Castle (2.6 miles south-east) and French Hospital (2.8 miles south-east). Green spaces nearby include Gad's Hill and Rede Common.

Map of Higham © OpenStreetMap contributors

Your questions about regrouting in Higham

Will you come out to Higham?

Yes. Higham is within the area we cover, which takes in towns, villages and rural addresses. Our work covers London and the South East. Let us know about access, parking and anything unusual about getting there when you book.

Do you cover Higham for regrouting?

Yes, Higham is within the area we cover. Our work covers London and the South East. You can ring 0345 464 0079 or send us an email and let us know what needs doing.

Do you guarantee regrouting?

Our one-year guarantee applies to all our work. We are also fully insured.

Is there any odour?

Possibly a little. Any smell clears as the sealant cures.

Will the old sealant be removed?

Yes. All of the old material is cut out and the joint cleaned.

Can you regrout just the shower?

Yes, that’s common. Shower grout tends to go before the rest, so many people regrout just that part.

Is it messy?

Tidy work is part of the job. We protect what’s around the joints, and we clear up when we are done.

I rent my home. Can I book you?

Yes, though it’s best to check with your landlord first. Many landlords are glad to have it sorted.

How we quote for regrouting

For a quick quote, just ask. What matters most is:

  • When we can work, for business premises
  • The number of rooms or windows
  • Any mould that needs treating
  • How easy the joints are to reach

Every job is a little different, so each one gets its own quote. The number of joints, how easy they are to reach and the sealant needed all play a part.

Asking for a quote

The more you tell us, the more accurate the quote. When you ask for a quote, tell us:

  • How we’d reach the joints
  • Where the job is, and your postcode
  • The problem you’ve noticed
  • Roughly how big the job is

Asking for a quote is easy: let us know the job and the location and its rough size. Photos by email help us understand the job.

Can I do it myself?

Sealing over old silicone is the commonest DIY error. New silicone will not bond to old, so it lifts and traps water and mould underneath. Everything old must be removed first.

Overfilling a joint is a classic DIY mistake. A heavy bead looks messy and copes badly with movement, and getting the depth right matters as much as the look.

20+ yearsMastic and sealant specialists
ARBOMaster approvedApproved applicator for Arbo sealants
Fully insuredDomestic, commercial and hotels
One-year guaranteeOn every job