Hampshire · England
Fareham Common Gutter Sealing
We cover Fareham Common for sealing leaking gutter joints, end caps, fascias, soffits and roofline trims. Old material cut out, joints cleaned and sealed neatly and a one-year guarantee.
- Damp patches inside below a leaking gutter
- Earlier gutter repairs that have peeled off
- Trim joints where the sealant has failed
When it isn’t the sealant
It helps to know what we can’t do:
- A gutter length that has split
- Boards that have decayed or split
- Brackets that have snapped or loosened
Not sure which it is? You can ring 0345 464 0079 or email us and we’ll tell you honestly.
What we seal
- Gutter joints
- Gutter end caps
- Garage door frames
- Soffit joints
- Roofline trims
- uPVC fascias
How we handle gutter sealing in Fareham Common
A leaking gutter joint marks the wall and wets the ground underneath. Resealing the joint is often all it needs, as long as the gutter is sound. If you have old sealant on roofline trims that has split and end caps that drip every time it rains, we can put it right, whatever the surface.
Houses in smaller places like Fareham Common can stand more in the open than those in a built-up town, so exposed walls and rooflines take more wind-driven rain. Joints on those sides are normally the first to go.
A 12-month guarantee comes as standard, so you’re covered after we’ve gone.
- Place
- Fareham Common (PO16, PO14)
- Region
- Hampshire
- Cover
- One year on every job
- Quote
- A clear price before work begins
- Telephone
- 0345 464 0079
- Updated
- 26 October 2026
When to call us in Fareham Common
A sealant applied to a damp or dirty joint won’t bond. Some quick repairs peel off within a season or two for this reason.
Any of these means the joints need attention:
- Dripping gutter ends
- Damp on an inside wall under a dripping gutter
- Leaking gutter joints and stop ends
- Open joints in fascias and soffits
For landlords with property near Fareham station, a gutter joint that drips onto the wall can turn into a damp complaint, so it’s worth checking.
What your quote should include
- What insurance they hold
- How much experience the applicator has
- Whether all the old sealant comes out first
- Whether you can choose the colour
What gutter sealing looks like in Fareham Common
Fareham Common is within about 1 mile of the coast, where wind-driven rain is a fact of life and, nearer the shore, so is salt air. Both are hard on gutter, fascia and roofline joints, which can dry out and crack sooner where a building faces the weather. Rainfall in the South East is lower than in much of the UK, yet outdoor joints still have to be sealed dry, so jobs are booked with the weather in mind.
Homes close to Parish Church of St Peter and St Paul include some older properties, and old and new materials meet at the roofline and walls, which is where sealant earns its keep. Schools such as Wykeham House School are buildings too, and its movement joints, gutters and trims need looking after like any other building’s.
Fareham Common is about 1 mile east of Fareham, in Hampshire. Every kind of property in Fareham Common can book us for gutter sealing, old or new, large or small. Every job comes with our 12-month guarantee. We cover 683 towns and villages across Hampshire.
Postcode districts we cover here for gutter sealing: PO16 and PO14. Streets in the area include Bath Lane, Osborn Road and High Street, and we cover them all. Fareham Common sits on or near the A32, so getting to you is simple. Neighbouring places we cover for gutter sealing include Wallington (1 mile north-east), Fareham (1 mile west), North Fareham (1 mile north), Boarhunt (2 miles north-east) and Crockerhill (2 miles north). Within a short drive, we also cover Gosport (3 miles south), Havant (8 miles east), Eastleigh (11 miles north-west), Horndean (8 miles north-east), Totton (15 miles west) and Chandler's Ford (13 miles north-west).
Local landmarks in Fareham Common
We work in homes and buildings around Harrison Primary School, The Red Lion Hotel and Cams Hill School and the streets around them. Fareham Common’s nearest station is Fareham station, roughly 0.8 miles west. Other landmarks nearby include Portchester Castle (2.8 miles east) and Carron Row Farm Museum (2.6 miles west). For a walk, there’s West of the River Alver and Portsdown Hill.
The process
Before we leave, we go over the finished joints with you and tell you how long to leave it. The visit itself normally takes an hour or two for a few joints, longer for a full run, depending on the size of the job. In a smaller place like Fareham Common, parking is seldom the issue; lanes, gates and long drives are worth mentioning. If the job is outside, tell us about side access and how high the joints are.
- First we trace the drip and check the gutter is not damaged.
- The old sealant and dirt are cleaned out of the joint.
- The joint is dried before sealing.
- A gutter sealant is applied to the joint.
- We check the run and clear debris near the joints.
How to prepare
- Where the joints are inside, avoid wetting them before we arrive
- Mention any sign-in or site rules at work premises
- Mention any tricky access
Getting a quote
Every job is quoted individually, so start by telling us what you need. Just phone 0345 464 0079 or send us an email with the details.
Advice
Different surfaces, different methods
Gutter end caps
Stop ends hold back water at the end of a run. A failed seal makes them leak.
Garage door frames
A fresh seal around the frame stops rain getting in.
What affects the cost of gutter sealing
The price is agreed before any work begins. It takes into account:
- How many rooms, windows or areas are involved
- How much there is to do
- How easy the joints are to reach
- Which sealant suits the joint
Every job is a little different, so we quote each one individually. Size, access and the product the joint needs all play a part, and we’ll explain the quote if you ask.
What we need to know
A few details help us give you an accurate quote. When you get in contact, it helps to mention:
- Pictures of the joints, sent by email
- How many joints, rooms or windows are involved
- Where the job is, and your postcode
- Whether it has been sealed before
Quotes start with a quick conversation. Describe the problem, the location and the size of the job, and we will talk you through what we’d do. Whenever you’re ready, call 0345 464 0079 or send us an email.
Your questions about gutter sealing in Fareham Common
Will you come out to Fareham Common?
Yes, we do. Our work covers London and the South East, and smaller places are part of that. The journey is planned ahead, so it helps to know about access.
I let a flat near Fareham station. Can you help?
Yes, landlords and agents are among the people we work for. You can ring 0345 464 0079 or email us with the details for a clear quote.
How long does the job take?
As a guide, most jobs take anything from an hour or two to a few hours. Larger jobs naturally take longer, and we will say how long yours will take.
Should I try DIY first?
That depends on the joint. High-level, external movement and fire-rated joints are professional jobs.
Are you an approved applicator?
Yes. We hold ARBOMaster approved applicator status and we are fully insured too.
How long should I leave it?
Many sealants skin over quickly but take longer to cure fully. We will tell you how long to leave the joint.
What sealant do you use?
Each joint gets the product that suits it. Where it moves, gets wet or faces the weather makes a difference, and we will explain our choice.
Do you offer different sealant colours?
Yes. White, clear and grey are common, and other colours are available for many products, and we agree the colour with you before we start.
Landlord and commercial work in Fareham Common
Housing providers, facilities teams and property managers book us too. We can quote a run of properties together, and we’re fully insured for the work.
For anyone letting property in or around Fareham Common, several properties can be quoted together. Send us the addresses and the work at each, and photos by email help.
Should I try it myself first?
If you do try it yourself, take your time over the preparation: remove every trace of old sealant, clean and dry the joint, and follow the product’s cure time. If it fails, we can still redo it.
Overfilling a joint is a classic DIY mistake. A thick, smeared bead looks untidy and does not move well, and the joint depth matters as much as the finish.