Essex · England
Little Braxted Fire Rated Sealant
Professional fire rated sealant in and around Little Braxted, with every bit of old sealant taken out first and a 12-month guarantee.
- Unsealed gaps around fire door frames
- Seals cut through by electricians, plumbers or data installers
- Gaps around pipes and cables through fire-resisting walls
Fire rated sealant for homes and businesses in Little Braxted
Ordinary silicone or decorators’ caulk in a fire-stopping gap is not a fire-rated seal. Anything unsuitable comes out first and reseal with a fire-rated product tested for that kind of gap. If you’re dealing with unsealed gaps around fire door frames and ordinary sealant used where a fire-rated product was needed, we can help, on service penetrations, pipe & cable gaps and linear gaps alike.
For a small place like Little Braxted, the journey and timings are agreed in advance, so the job can fit around bookings, guests or opening times where possible.
Our work is backed for twelve months, and the guarantee is the same wherever you are.
- Location
- Little Braxted (CM8)
- Region
- Essex
- Cover
- One year on every job
- Quotes
- A clear price before any work starts
- Telephone
- 0345 464 0079
- Last updated
- 26 October 2026
Fire rated sealant in Little Braxted: local notes
Workplaces and the common parts of blocks of flats in England need a fire risk assessment under the Regulatory Reform (Fire Safety) Order 2005, which is often where open fire-stopping gaps are first noticed. We apply fire-rated sealant to the assessor’s or designer’s specification and the product’s tested details.
Community buildings like Church of St Nicholas are part of the picture too: older buildings that have had new heating or wiring often have service gaps worth checking. Managing a site like Maltings Academy? Then service openings in fire-resisting walls need checking after any refurbishment.
Little Braxted is about 1 mile east of Witham, in Essex. Every kind of property in Little Braxted can book us for fire rated sealant. Every job comes with our one-year guarantee. Our area takes in 644 places across Essex. There’s also a page for Chelmsford, roughly 9 miles from Little Braxted.
All of CM8 is within our area for fire rated sealant, from the main roads to the quietest streets. Other places close to Little Braxted include Witham (1 mile west), Rivenhall End (1 mile north), Rivenhall (2 miles north), Faulkbourne (3 miles north-west) and Silver End (4 miles north-west). Within a short drive, we also cover Colchester (12 miles north-east), Chelmsford (9 miles south-west), Braintree (7 miles north-west), Maldon (5 miles south), Rayleigh (15 miles south) and Wickford (15 miles south-west).
What’s near Little Braxted
Around Little Braxted, our work takes us to homes and buildings near Red Lion Inn and Whet Mead, among other places. The closest station to Little Braxted is Witham station, about 1 mile west of the centre. Well-known places in the area include Cressing Temple (3.4 miles north-west). The countryside around Little Braxted includes Shut Heath Wood.
Landlords, agents and businesses in Little Braxted
We work for landlords and letting agents as well as homeowners. Resealing between tenancies keeps a property looking cared for.
Letting agents often deal with us directly. Tell us the address, the job and how access works.
What happens if it’s left?
Items left open on a fire risk assessment tend to come back at the next review. Having them sealed and recorded now gives you evidence that the item was dealt with. Around Little Braxted, older homes often have timber in their floors and frames, and water through a failed joint can rot timber if it’s left.
Combining jobs into one visit generally makes better use of the time than several visits, so it’s worth mentioning everything you’d like done. You’ll get one clear quote for the whole job.
What you get with us
- ARBOMaster approved applicator
- 4.9 on Google from 180+ five-star reviews
- More than 20 years in sealant work
- A 12-month guarantee on all work
Read our cost guide and our reviews.
Looking after it afterwards
Simple care keeps the joints in good condition. Our advice:
- File the fire-stopping record where your assessor can find it
- Ask every contractor to reseal any fire stopping they disturb
- Include fire stopping when you schedule refits
- Photograph sealed gaps before they’re covered up
Leave the sealant to cure fully before painting near it. Some fire-rated sealants can be painted and some cannot, so ask us which we used.
It’s easiest to seal gaps while they’re few and easy to reach. Leave them and each new job adds another hole and the list grows.
Common questions in Little Braxted
Will you come out to Little Braxted?
Yes, smaller places are covered as well as towns. We work across London and the South East. Just mention lanes, gates or anything else about the route when you book.
Is Little Braxted in your area for fire rated sealant?
Yes. We work across London and the South East, and Little Braxted is part of that. You can call 0345 464 0079 or drop us an email and tell us what needs doing.
What’s the difference between intumescent and fire-rated sealant?
Intumescent describes a material that swells in heat. Intumescent sealants are a type of fire-rated sealant.
I’m a tenant. Can you help?
Yes, but check with your landlord or agent first. Many landlords are glad to have it sorted.
Do I have to be there?
That depends on where the joints are. Inside work needs someone to give us access.
Will we have a record of what was sealed?
Yes. Every gap we seal is listed with the product used.
Do you take out the old sealant first?
Yes. Sealing over old sealant is the main reason resealing fails early, and it’s something we never do.
How long does fire rated sealant take?
It depends on the size of the job, but most jobs take from a few hours to a few days, depending on the number of gaps and the access. We will give you a better idea when we quote.
Common problems we fix in Little Braxted
Many open fire-stopping gaps are made after the building is finished. Electricians, plumbers and data installers drill through walls and ceilings and the hole round the new service is not always sealed again.
If you can see any of these, it’s time to have the joints looked at:
- Fire seals that have cracked with movement
- Holes left by a change of layout
- Joints picked up in a fire-stopping survey
- Open joints along the top of partitions
For landlords with property near Witham station, new cables or pipes through a fire-resisting wall leave a gap that needs the right sealant.
Before you book anyone
- Whether they’re fully insured
- How the colour is chosen
- What preparation is included
- Is VAT in the price?
When it isn’t the sealant
We will not take on work that will not last, so here’s what sealant cannot put right:
- Issuing a fire rating or certificate for a building
- Walls or floors that weren’t built to resist fire
- Big openings where sealant alone is not the tested solution
If you are not sure, just call 0345 464 0079 or send us an email and we will give you a straight answer before you book.
Joints and surfaces we work on
- Plasterboard & masonry
- Service penetrations
- Flats & HMOs
- Linear gaps
- Pipe & cable gaps
- Door frames
How the visit works
Good joint work is mostly preparation, so that’s where we spend the time. Joints are cleaned back and dried before anything new goes in. All told, the work takes a few hours for a handful of gaps, and longer for a whole building. Somewhere as small as Little Braxted, access is often the only tricky part. For outside work, also let us know about exposed walls and any outbuildings involved.
- Access to each area is agreed so the work can run in order.
- We take out any damaged or unsuitable sealant.
- Gaps are cleaned of dust and loose material.
- We apply and tool the sealant to the product’s tested detail.
- We record what was done and flag anything that needs a different system.
Preparing for the visit
- Try not to wet indoor joints just before the visit
- Clear the area around the work
- Tell us about any previous sealing or DIY attempts
Getting a quote
We quote each job on its own, so the first step is telling us about yours. Simply call 0345 464 0079 or drop us an email and describe the job and send photos if you have them.
Advice
Should I try it myself first?
Sealing over old silicone is the commonest DIY error. New silicone will not bond to old, so it lifts and traps water and mould underneath. Everything old must be removed first.
Not every job suits DIY: work at height, external movement joints, fire-rated sealant and large areas need the right product, the right access and the right method.