Scottish Borders · Scotland
Fire Rated Sealant in Gattonside
Intumescent and fire-rated sealant around gaps, frames and service penetrations for householders, landlords and businesses in Gattonside. Fully insured, ARBOMaster approved and guaranteed for a year.
- Cracked or shrunken fire-rated sealant
- Joints picked up in a fire-stopping survey
- Open joints along the top of partitions
DIY versus a professional finish
The difference is mostly in the preparation and the product. Joints are cleaned back to sound surfaces and dried, and the sealant is matched to the joint and its conditions, and the work is guaranteed for a year.
If you’re set on DIY, put the effort into preparation: remove every trace of old sealant, clean and dry the joint, and follow the product’s cure time. If it does not work out, we can still put it right.
Fire rated sealant in Gattonside, done properly
Later work by other trades often breaks through fire stopping, especially in flats, HMOs, offices and schools. A new cable run or a replaced pipe can leave an open hole behind. Those are the gaps we close, using a tested fire-rated product. If you have open holes round services passing through fire walls and standard silicone or caulk in a fire-stopping gap, we can put it right.
Work in a place like Gattonside is planned ahead, journey included, so the job can fit around guests, residents or opening hours where possible.
We stand behind the work with a 12-month guarantee.
- Where
- Gattonside (TD6)
- Wider area
- Scottish Borders
- Cover
- One year on every job
- Quotes
- Quoted before any work starts
- info@mrmastic.co.uk
- Page updated
- 26 October 2026
When it is not the sealant
It helps to know what we can’t do:
- Fire risk assessments, which need a qualified assessor
- Sign-off of the building, which sits with building control or your assessor
- Doors that are not fire doors in the first place
If in doubt, drop us a line at info@mrmastic.co.uk and we’ll say what we think before booking.
What we seal
- Door frames
- Flats & HMOs
- Plasterboard & masonry
- Service penetrations
- Linear gaps
- Pipe & cable gaps
Why act early in Gattonside
An open gap in a fire-resisting wall is a route for smoke and fire. Sealing it properly restores what the wall was there to do, and the work involved is often modest. Out of town in Scotland, exposed walls take a lot of weather, and once water gets behind a failed joint, damp in stone or harled walls is slow to dry out.
Rather than a set price list, we price the job in front of us: how many joints, what’s in them now and how we reach them. The price is agreed before we begin.
What you get with us
- Sanitary silicone with an anti-fungal additive in wet areas
- Rated 4.9 stars on Google
- Full insurance on every job
- Over 20 years’ experience
Take a look at how sealant jobs are priced or what customers say.
Towns and villages near Gattonside
More services for Gattonside
FAQs for Gattonside
Do you cover smaller places like Gattonside?
Yes, smaller places are covered as well as towns. We work across all of Scotland. Just mention lanes, gates or anything else about the route when you book.
Do you work in hotels near Gattonside?
Yes, hospitality work, including hotels, is part of what we do. Work can be planned room by room, and out-of-hours working can be arranged.
Do I need to be at home?
Access is agreed with you when the job is booked. For inside work, that normally means someone being in.
What does intumescent mean?
Intumescent means it swells when heated, helping close the gap. Intumescent sealants are one kind of fire-rated sealant; which product suits depends on the gap, the substrate and the service.
Is standard sealant good enough for a fire gap?
No. Where a fire-rated seal is needed, it has to be a product tested for that use.
Are you fully insured?
Yes. We are fully insured for every job we do.
Can you give us a record of the work?
Yes. You get a list of where we worked and what we used for your files.
Do you seal gaps around fire door frames?
Yes. The joint between frame and wall is sealed with a fire-rated sealant. The door, its seals and closer are for a door specialist.
What fire rated sealant looks like in Gattonside
Scotland has its own building regulations, the Building (Scotland) Regulations, with technical handbooks. Fire-rated sealant is installed to the manufacturer’s tested details, though we do not certify buildings or do fire risk assessments. Gattonside has hotels and guest accommodation in and around it. For hotels, a room-by-room programme keeps most rooms in use while the work goes on.
If you let a flat or house near Tweedbank station, fire-rated sealant around pipes and cables through walls and floors needs making good whenever new services go through. Around Gattonside, as everywhere, fire rated sealant is only as good as the preparation behind it.
Gattonside is about 3 miles east of Galashiels, in the Scottish Borders. Homes, rented property, offices and hotels in Gattonside can book us for fire rated sealant, old or new, large or small. Every job comes with our one-year guarantee. Our the Scottish Borders coverage runs to 89 places, Gattonside among them. Edinburgh is on our list too, about 30 miles from Gattonside.
We cover every part of TD6 for fire rated sealant and the streets around it. Fire rated sealant is available to properties on The Loan, Priors Road and Monkswood and the roads around them. Other places close to Gattonside include Melrose (1 mile south), Darnick (1 mile south-west), Newstead (1 mile south-east), Tweedbank (2 miles west) and Langlee (2 miles west). Further out, we also cover Galashiels (3 miles west), Hawick (13 miles south), Kelso (11 miles east), Selkirk (6 miles south-west), Jedburgh (11 miles south-east) and Wilton (13 miles south).
What’s near Gattonside
Gattonside’s nearest station is Tweedbank station, roughly 1.3 miles west. Nearby you’ll also find Melrose Motor Museum (0.5 miles south-east) and Castle Holydean (3 miles south). Open spaces near Gattonside include Eildon Hill North and Bemersyde Moss.
Landlord and commercial work in Gattonside
If you manage several properties in or around Gattonside, jobs at different addresses can be quoted together. Just tell us the addresses and what each one needs.
We work for landlords and letting agents as well as householders. Sealant work between tenants is a simple way to keep a property in good order before the next move-in.
Aftercare tips
Aftercare is simple, and it makes a real difference:
- Report cracked or damaged seals as soon as you notice them
- Check whether a sealant can be painted before decorating over it
- Keep general-purpose foam and caulk away from fire-stopping gaps
- Keep the record of products and locations with your fire safety documents
Leave the sealant to cure fully before painting near it. Some fire-rated sealants can be painted and some can’t.
An open gap isn’t only a fire issue: they also let noise, draughts and sometimes pests through. Dealing with them early helps with all of these.
What affects the cost of fire rated sealant
We quote each job individually. These are the things that affect it:
- How many areas need sealing
- Any mould that needs treating
- The product the joint needs
- Working hours on commercial sites
Combining jobs into one visit is normally more efficient than separate visits. You will get one clear quote for the whole job.
Helping us quote
Photos by email are helpful but not essential. Try to tell us:
- How many joints, rooms or windows are involved
- The problem you’ve noticed
- Photos by email, if that’s easy
- The type of property
For a quote, drop us a line at info@mrmastic.co.uk and tell us where the job is and what the problem looks like. We’ll give you a clear quote before any work starts.
How the visit works
We bring everything the job needs with us, so you don’t need to buy or prepare anything. After a quick look at the joints together, the area is protected and the work begins. Most jobs take from a few hours to a few days, depending on the number of gaps and the access. Around Gattonside, distance and access matter more than parking. Let us know how to find you and how to reach the joints.
- Access to each area is agreed so the work can run in order.
- Old, damaged or unsuitable sealant is removed.
- Gaps are cleaned of dust and loose material.
- The fire-rated or intumescent sealant is applied and tooled to the tested detail.
- Locations and products are written up and any gaps unsuitable for sealant are flagged.
Before we arrive
- Plan for the work area to be out of bounds to pets and children
- Let us know about parking restrictions
- On commercial sites, let us know about site rules
Get a quote
Every job is quoted individually. Simply send an email to info@mrmastic.co.uk and describe the job and send pictures if you have them.