East Sussex · England
Bathroom & kitchen resealing in Broyle Side, East Sussex
Bath, shower, basin, wet room, worktop and sink resealing for homes and businesses in Broyle Side and across East Sussex. ARBOMaster approved applicators, fully insured, with a 12-month guarantee.
- Water escaping at the shower enclosure
- A reseal done over the top of the old bead
- Cracked, shrunken or lifting silicone
Should I try it myself first?
Sealing over old silicone is the commonest DIY error. New silicone will not bond to old, so it peels away and traps moisture behind it. Everything old must be removed first.
Some sealant jobs are within reach of a careful DIYer, such as a straightforward joint indoors. The common mistakes are sealing over old sealant, sealing a damp joint and using far too much.
About our bathroom resealing in Broyle Side
A shower joint gets soaked every day. Trays, enclosures, screen profiles and wet room floors all need a flexible, waterproof seal. They’re resealed with anti-fungal sanitary silicone, tooled smooth so water runs off instead of sitting in a ridge. We’re often asked to deal with shrunken sealant along the back of a worktop and a reseal done over the top of the old bead, on basins & vanity units, shower trays & enclosures and kitchen worktops & upstands.
Homes around Broyle Side are mostly houses and cottages rather than flats. Sealant and grout wear out here just as they do anywhere: old material cut out, joints cleaned and a fresh finish laid.
Each job carries a 12-month guarantee.

- Place
- Broyle Side (BN8)
- Wider area
- East Sussex
- Guarantee
- 12 months on all our work
- Quote
- A clear price before we start
- Telephone
- 0345 464 0079
- Page updated
- 26 October 2026
Landlords, agents and businesses in Broyle Side
We regularly work with letting and managing agents. Tell us the address, the job and how access works and we’ll quote.
Water getting past a failed joint can damage the building, which is a bigger problem in a rented property. Resealing at the right time is simple maintenance that we can handle for you.
How we quote for bathroom resealing
Call for a quick quote. What matters most is:
- Any working-time requirements on site
- Access and height
- The product the joint needs
- How much old sealant there is and how hard it is to remove
We don’t show prices on the website, because each job is priced on what it involves. Call for a quick quote.
What we need to know
The more you tell us, the more accurate the quote. When you ask for a quote, tell us:
- The rough size of the job
- Any previous sealing or DIY work
- A few photos by email, if you can
- Whether it’s a home or a business
For a quote, call 0345 464 0079 or email us with the location and a short description of the problem. We’ll send you a clear quote before any work starts.
Your questions about bathroom resealing in Broyle Side
Will you come out to Broyle Side?
Yes. Broyle Side is within the area we cover, which takes in towns, villages and rural addresses. Our work covers London and the South East. Just mention lanes, gates or anything else about the route when you book.
I let a flat near Glynde station. Can you help?
Yes, landlords and agents are among the people we work for, and several properties can go on one quote. Just ring 0345 464 0079 or email us with the address and what needs doing, and we will give you a clear price.
Can you get rid of the black mould in my sealant?
Yes, we replace the mouldy bead. Sprays can fade the marks, but cutting it out and resealing is what lasts. Airing the room well helps stop it returning.
Do you remove the old sealant?
Yes. Sealing over the old bead is the commonest cause of early failure, and it’s something we never do.
Do the sealants smell?
Some sealants have a smell while they cure, which fades as it sets. Opening a window helps.
Where is Mr Mastic based?
Mr Mastic is based in Crawley. We cover Broyle Side and the rest of East Sussex.
Are you fully insured?
Yes. We are fully insured, and we can confirm the details when we quote.
Do you do kitchens as well as bathrooms?
Yes, often alongside a bathroom. Next to the sink we use a food-safe product where it’s needed.
Keeping the joints in good condition
After the cure time, these simple habits help:
- Use gentle cleaners on the silicone
- Give the silicone its full cure time
- Move toiletries away from the joint
- Keep an eye on the corners, where splits start
Mould needs damp, so keep the room aired. Run the extractor fan during and after a shower, so the bead dries out between uses.
Watch for the early signs: a corner lifting, a gap behind the bead, a dark line under the silicone or a damp patch on the ceiling below. Any of these means the joint needs attention.
Nearby places to Broyle Side
Other services in Broyle Side
The process
At the end, we look at the finished work together. The visit itself usually takes two to three hours for a typical bath, depending on how much old sealant there is, depending on the amount of work. Somewhere as small as Broyle Side, access is often the only tricky part. For outside work, also let us know about exposed walls and any outbuildings involved.
- First, each joint is checked for movement and signs of water.
- The old silicone is cut out completely, along with the film it leaves on the tiles.
- The joint is cleaned, degreased and treated for mould.
- With the joint dry, and any bath loaded with water, a single bead of anti-fungal silicone is applied.
- We tool the bead to a neat finish and give you the cure time, usually around 24 hours.
Before we arrive
- Tell us about any water getting in
- Let us know about earlier repairs to the joints
- Try not to wet indoor joints just before the visit
Get a quote
If you are in Broyle Side and need bathroom resealing, call 0345 464 0079 or email us. Tell us what the problem is and where, and you will get a clear quote before work begins.
Advice
Surface by surface
Wet rooms
A wet room floor and its walls can move independently, so the corners need a flexible seal, not grout. Cracked grout in a corner can be cut out and replaced with silicone.
Sinks & splashbacks
Where a splashback meets the worktop, there’s a joint that catches every splash. It’s resealed in white, clear or a colour to suit.
Broyle Side homes and their sealant
Most of the South East has hard water, which leaves limescale on sealant, grout and fittings.
Managing a site like Ringmer Community College and Sixth Form? Then its toilets, changing areas and kitchens need their sealant renewed like any other building’s. Rented homes near Glynde station change hands often, and mouldy sealant is one of the first things a new tenant notices, so it’s worth renewing between lets. For an older house near a landmark such as The Parish Church of St Mary the Virgin, walls and floors in older homes can move, and sealant and grout show it first.
Broyle Side is about 3 miles north-east of Lewes, in East Sussex. We carry out bathroom resealing for homes and businesses in Broyle Side and the surrounding area. Our East Sussex coverage runs to 289 places, and Broyle Side is one of them. For nearby work, see our Brighton page.
Our applicators cover all of the BN8 postcode area for bathroom resealing. Whether your property is on Broyle Paddock, Ballard Drive and Turnpike Close or anywhere close by, our applicators can take on the job. Close by, we work in Norlington (1 mile west), Upper Wellingham (2 miles west), Rose Hill (2 miles north), Barcombe Mills (2 miles north-west) and Isfield (3 miles north). We also work in nearby towns such as Eastbourne (12 miles south-east), Seaford (9 miles south), Lewes (3 miles south-west), Hailsham (8 miles east), Crowborough (11 miles north) and Uckfield (5 miles north).
Local landmarks in Broyle Side
We work in homes and buildings around Ringmer Primary and Nursery School and The Green Man pub and the streets around them. For rail, the closest station is Glynde station, roughly 2.9 miles south. Well-known places in the area include Museum of Agricultural Bygones (0.8 miles south-east) and Lewes Castle (3.6 miles south-west). Green spaces nearby include Malling Down and Cliffe Hill.
What sealant work cannot fix
We’d rather tell you now than do work that will not last, so these are the limits:
- Failed grout lines across the wall
- Leaks from a shower valve, waste or pipework (a plumber’s job)
- A bath or tray that moves because it is not properly supported
If you are not sure, just ring 0345 464 0079 or send us an email and we’ll give you a straight answer before you book.
Surfaces we seal
- Basins & vanity units
- Baths
- Wet rooms
- Shower trays & enclosures
- Sinks & splashbacks
- Kitchen worktops & upstands
